Ariens Path-Pro 136E User Manual download pdf (Page 17)

Editing Your Program

Let’s try editing the program by expanding it with another ramp and soak step and

adding a jump loop. We’ll jump to Step 1 and repeat Steps 1

6 two more times. This

is accomplished by programming a Jump Step (JS)

1 and Jump Count (JC)

When your 920 goes through the program and reaches Step 6, it jumps back to Step

and repeats the program two more times.

By this time you should understand the basic concept of the Series 920 and be able to

get around on your own. Remember that the MODE key takes you through the menus.

Use the UP/DOWN keys to select parameters and values, and press ENTER.

Return to the PROGRAM menu.

Enter FILE?

(1),

Step (4). We are going to change this step type from a STOP

step to a

SETPOINT

step. This will be our second ramp. Use Table 3 to enter

values into the corresponding parameters.

Table 3 -

Editing

Your

Program,

Steps 4-7.

Once you have edited your program, run it again and watch its progress.

Adding an AUTOSTART Step Type

The Series 920 can also automatically start your program, or a step, on a specified

day and time. When you use AUTOSTART, it stops your program, and waits for the

day and time you entered under the AUTOSTART step type. The Series 920 then

executes the next sequential step. AUTOSTART allows you to wait up to seven days

in the future; day 0 is always the current day.

The

days accumulated increases by

1 every time the Real Time clock goes from 2359 to

0O:OO.

If 0 is programmed for

DAY, and the Real Time clock is greater than the programmed AUTOSTART time,

the AUTOSTART waits 6 days along with the programmed time. If day is left blank,

the program begins each day at the real time programmed, regardless of the day.

Go to the PROGRAM menu.

Edit Step 7 from a STOP step to an AUTOSTART step.

Follow the table below for input values. This step will wait for approximately five

minutes in the future.

FILE

STEP#

STEP TYPE DAY

HOUR

MIN

Table 4

AUTOSTART 0

Current Hours

Current Minutes

Adding the

STOP

AUTOSTART Step.

Run this file starting at Step 7 and observe. The Series 920 will now wait until the

real time of day matches the programmed value.

Sample Program, Chapter 3

WATLOW Series 920 User’s Manual

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Comments to this Manuals

No comments

Ariens Path-Pro 136E User Manual Page 17

Comments to this Manuals

Related products and manuals for Garden tools Ariens Path-Pro 136E