Ariens Path-Pro 136E User Manual download pdf (Page 65)

Press the MODE key until the HOF

XX.XX

parameter appears on the

alphanumeric display. (The decimal point will not appear on the display of

your control.)

Use the UP/DOWN keys to adjust the alphanumeric dis-

play on the 920 to match the reading on the DVM. Once the two readings

match, press the ENTER key.

Press the MODE key until ATZ

XXXX

appears on the alphanumeric

display. Set the precision decade box to the correct LOW setting from

Table 12 that corresponds to the type of 920 unit you have. Allow 10 sec-

onds for the unit to stabilize and then press the ENTER key.

Press the MODE key until ATG

XXXX

appears on the lower display. Set

the precision decade box to the correct HIGH setting from Table 12 that

corresponds to the type of 920 that you have. Allow 10 seconds to stabi-

lize and then press the ENTER key. The unit is now calibrated for

RTD.

Remove power from the Series 920. Remove wires from

#2,

and

#3.

Set DIP Switch

to the OFF

position.

NOTE:

For

DIN curve

RTD, enter

the

SPCLFUNC menu

and use the

MODE

key to advance to

the RTD parameter.

Select

DIN.

Table 12

RTD

Calibration

Settings

for

JIS

WATLOW

Series

920 User’s

Manual 65

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 79 80

Comments to this Manuals

No comments

Ariens Path-Pro 136E User Manual Page 65

Comments to this Manuals

Related products and manuals for Garden tools Ariens Path-Pro 136E