Ariens 932 Series Service Manual download pdf (Page 9)

2 - 9

Understand:

How to operate all controls.

The functions of all controls.

How to STOP in an emergency.

Before starting engine, disengage control(s).

Use only approved extension cords and receptacles

when starting units equipped with electric starter. DO

NOT connect electric starter cord to any wiring system

that is not a three-wire grounded system.

ALWAYS allow unit and engine to adjust to outdoor

temperatures before clearing snow.

Always be sure of your footing, especially when

operating in reverse or leaving the operator’s position.

Walk, never run during operation.

DO NOT overload the machine capacity by attempting

to clear snow at too fast a rate.

DO NOT operate at too fast a rate.

Slow down and turn corners slowly.

Do not operate in reverse unless absolutely necessary.

ALWAYS back up slowly. Always look down and

behind before and while backing.

Disengage attachment drive when traveling from one

work area to another.

Abnormal Vibrations are a warning of trouble. Striking a

foreign object can damage unit. Immediately stop unit

and engine. Remove key and wait for all moving parts

to stop. Remove wire from spark plug. Inspect unit and

make any necessary repairs before restart.

Before cleaning, removing clogs or making any

inspections, repairs, etc.: disengage clutch(es),

stop unit and engine, remove key, allow moving

parts to stop. Allow hot parts to cool.

Run unit a few minutes after clearing snow to prevent

freeze-up of attachment.

Disengage attachment when not in use. Disengage all

clutches before starting engine. Adjust runners to clear

gravel or crushed rock surfaces safely.

Disengage clutch bail when not in use. Before starting

engine: disengage clutch bail. DO NOT use on gravel

or crushed rock surfaces.

Check clutch and brake operation frequently. Adjust

and service as required. All motion of auger must stop

quickly when bail is released.

Never leave a running unit unattended. ALWAYS

disengage PTO, lower the attachment, set parking

brake, and shut off engine before leaving unit.

ALWAYS remove key to prevent unauthorized use.

Never carry passengers.

Check clutch and brake operation frequently. Adjust

and service as required. All motion of drive wheels and

auger/impeller must stop quickly when control levers

are released.

Adjust brush height before operating. Engage traction

drive clutch before attachment clutch. If brush is set too

low or if terrain is irregular brush can drive machine

rearward.

DO NOT operate on steep slopes. DO NOT clear snow

across the face of slopes. Keep all movement on

slopes slow and gradual. DO NOT make sudden

changes in speed or direction. Use a slow speed to

avoid stops or shifts on slopes. Avoid starting or

stopping on a slope.

DO NOT park unit on a slope unless absolutely

necessary. When parking on a slope always block the

wheels.

ALWAYS shut off engine, remove key, and close fuel

shut-off valve or drain fuel when transporting unit on a

truck or trailer.

Use extra care when loading or unloading unit onto

trailer or truck.

Secure unit chassis to transport vehicle. NEVER

secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

Keep unit free of ice or other debris. Clean up oil or fuel

spills.

This product is equipped with an internal combustion

type engine. DO NOT use unit on or near any

unimproved, forest-covered or brush covered land

unless exhaust system is equipped with a spark

arrester meeting applicable local, state or federal laws.

A spark arrester, if it is used, must be maintained in

effective working order by operator.

Fuel is highly flammable and its vapors are explosive.

Handle with care. Use an approved fuel container.

NO smoking, NO sparks, NO flames. ALWAYS allow

engine to cool before servicing.

NEVER fill fuel tank when engine is running or hot from

operation.

NEVER fill or drain fuel tank indoors.

Replace fuel cap securely and clean up spilled fuel.

Never fill containers inside a vehicle or on a truck or

trailer bed with a plastic liner. Always place containers

on the ground away from your vehicle before filling.

When practical, remove gas-powered equipment from

the truck or trailer and refuel it on the ground. If this is

not possible, then refuel such equipment on a trailer

with a portable container, rather than from a gasoline

dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank

or container opening at all times until fueling is

complete. Do not use a nozzle lock-open device.

If fuel is spilled on clothing, change clothing

immediately.

In case of internal contact, DO NOT induce vomiting!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 9

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series