Ariens 932 Series Service Manual download pdf (Page 18)

5 - 18

5.1 DEFLECTOR REMOTE

Deflector must stay in selected position while throwing

snow.

If deflector does not stay in set position:

1. Tighten nut beneath the control panel to increase

friction on pressure flange (

Figure 9).

Figure 9

If deflector does not follow full range of travel:

1. Push deflector remote all the way forward.

2. Loosen adjusting nuts on cable support bracket.

3. To adjust the deflector lower, slide cable down.

Tighten bottom nut.

4. To adjust deflector higher, slide cable up. Tighten

top nut.

5. Check travel and repeat adjustment as necessary.

5.2 DISCHARGE CHUTE

If chute does not stay in position while operating,

tighten nut on carriage bolt at pivot point to increase

tension on spring (

Figure 10).

Smooth and easy rotation of properly lubricated chute

with crank is obtained by adjusting pinion and chute

gear teeth so they mesh together.

Figure 10

5.3 RUNNERS

Runners should be adjusted (Figure 11) as conditions

require.

1. Position unit on a hard, flat, smooth level surface.

2. Adjust runners by inserting a spacer of desired

thickness under center of scraper blade, loosen

runner hardware, slide runners to flat surface.

Allow 1/8

in. (3 mm) between scraper blade and

hard smooth surfaces. Allow 1-1/4

in. (30 mm)

between scraper blade and uneven or gravel

surfaces. Retighten hardware.

NOTE: Keep housing level by adjusting runners

equally.

SECTION 5 - SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

1. Nut

2. Pressure Flange

3. Adjusting Nuts

4. Cable Support Bracket

OS6700

1. Pinion

2. Chute Gear

3. Carriage Bolt

4. Spring

OS6730

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 18

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series