Ariens 932 Series Service Manual download pdf (Page 27)

9 - 27

9.3 FRICTION PLATE

The firction plate can be removed and inspected when

the drive system, friction plate, and axle have been

removed. Refer to the appropriate sections of this

manual for more information.

1. Disconnect the friction plate return spring, Figure

22.

2. Lift friction plate off the hex shaft.

3. Inspect for wear.

4. When reassembling apply anti-seize to the shaft

before installing the friction plate.

9.4 FRICTION PLATE HEX SHAFT

To remove the shaft (Figure 21), place the unit in the

belt service position. Remove the front half of the

frame.

1. Remove the belt from the pulley.

2. Unscrew the bolt from the pulley and remove the

pulley.

3. Remove the hub key.

4. Tip the frame forward and remove the drive

system, friction wheel, and friction plate. Refer to

appropriate sections of this manual for more

information.

5. Pull the shaft out of the bearings.

6. Reassemble in reverse order.

When installing the friction plate to the hex shaft, use

anti-seize on the shaft.

Figure 22

1. Friction Plate

2. Bearing Assembly

3. External Ring

4. Bearing

5. Traction Clutch

6. Return Spring

PS1051

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Ariens 932 Series Service Manual Page 27