Ariens 932 Series Service Manual download pdf (Page 16)

4 - 16

IMPORTANT: To avoid bending bottom cover, when

tipping unit apart, support handlebars firmly or tip unit

up on housing and remove bottom cover by removing

four cap screws before separating unit.

6. Support Sno-Thro frame and housing (Figure 6).

7. Remove top two cap screws and loosen lower cap

screws holding blower housing to frame (one on

each side).

8. Hold the brake away from the attachment pulley

and separate housing from unit. Lower handlebar

on floor.

9. Remove attachment drive belt from lower pulley

(hold brake away from belt).

Figure 6

Replace Attachment Drive Belt ()

1. Place new belt onto lower pulley and while holding

brake out of way, tip unit together.

2. Secure blower housing to frame with cap screws.

3. Place belt onto engine sheave.

4. Make sure engine sheave and attachment pulley

align, and belt rides on idler.

5. Replace belt finger.

IMPORTANT: BELT FINGER MUST BE between 1/16

to 1/8

in. (1.6–3 mm) from belt with attachment clutch

engaged or belt grabbing may occur causing impeller

to rotate while attachment clutch is disengaged.

6. Adjust clutch per Attachment Clutch/Impeller Brake

Adjustment below.

7. Replace chute crank and secure with spring pin.

8. Replace belt cover and secure with screws.

Figure 7

4.10 TRACTION DRIVE BELT

REPLACEMENT

NOTE: Housing and frame must be tipped apart and

attachment drive belt removed from engine sheave in

order to change traction drive belt (

Figure 6 & 7).

1. Remove attachment drive belt (See Remove

Attachment Drive Belt).

2. Pull idler away from traction drive belt and remove

belt from idler, camshaft pulley and driven pulley (it

may be necessary to turn camshaft pulley using

recoil starter handle).

NOTE: To gain clearance, engage traction clutch and if

necessary pull back attachment brake/idler arm.

3. Replace traction drive belt.

4. Replace attachment drive belt (See Replace

Attachment Drive Belt).

CAUTION: Always support Sno-Thro frame and

housing when loosening the cap screws holding

them together. Never loosen cap screws while

unit is in service position.

1. Pinion and Gear

2. Spring Clip Pin

3. Chute Crank

4. Housing Bolt Holes

5. Bottom Cover

6. Belt Cover

7. Universal Joint

OS1731

CAUTION: Always support Sno-Thro frame and

blower housing when loosening the cap screws

holding them together. Never loosen cap screws

while unit is in service position.

1. Belt Finger

2. Attachment Drive Belt

3. Traction Drive Belt

4. Camshaft Pulley

5. Traction Belt Idler

6. Engine Sheave

7. Attachment Pulley

8. Attachment Belt Idler

OS6810

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 16

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series