Ariens 932 Series Service Manual download pdf (Page 31)

11 - 31

11.1 ALUMINUM GEAR CASE

1. Remove auger/impeller and gear case from

housing referring to Auger/Impeller Section.

2. Remove eight bolts that hold right and left gear

case halves together (

Figure 26).

3. If flange bushings need replacement, first remove

seals from outside of gearcase halves with a

screwdriver. Flange bushings can then be pressed

out from outside in with a bearing driver. Bushings

are very lightly pressed in.

4. When replacing bushings make sure the flat on the

flange of bushing fits in the inside notch of the

case.

5. There are two special thrust washers, one on

either side of worm gear. If burred or worn, they

should be replaced.

6. Holding the worm gear on rake shaft is a wood ruff

key.

7. Remove bronze bushing from front of worm shaft

by sliding it off. Replace if necessary. Notice that a

flat on the bushing flange positions the bearing

inside the gearcase.

8. Behind rear bronze bushing is a seal which fits into

a groove in gearcase. It should be replaced at time

of repair.

9. Rear bushing is a larger diameter than one in front,

but are identical in design. Replace if necessary.

10.If replacement of thrust collar is necessary, drive

out groove pin towards direction of least

resistance.

11.Inspect worm shaft for burrs or black coloration. If

either show up, replace shaft.

12.Prior to re-assembly, apply anarobic sealant to a

clean surface. Allow to cure for 24 hours.

Reassemble. Make sure the flats on the bushings

are in their proper place.

This case requires Ariens L-2 P/N 00008000 and

should be half full.

After assembly is complete you should be able to turn

input shaft freely.

Auger/impeller gearcase is lubricated with Ariens L-2

(P/N 00008000). Check lubrication by removing filler

plug. Lubrication should be even with hole with unit

sitting level. It may be necessary to insert a wire into

the hole to check level. Unit will not be damaged by

over-lubricating.

Figure 26

SECTION 11 - GEAR CASE

1. Oil Seal

2. Gear Case RH

3. Flange Bushing

4. Thrust Washer

5. Worm Gear

6. Gearcase LH

7. Worm Shaft

8. Roll Pin

9. Bearing

10.Thrust Collar

11.Woodruff Key

12.Bronze Bushing

13.Seal

1 2 ... 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 31

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series