Ariens 932 Series Service Manual download pdf (Page 30)

10 - 30

10.4 RUNNERS

Runners should be adjusted as conditions require

(

Figure 25). Raising or lowering runners controls

distance scraper blade is held above surface being

cleared.

When operating machine on gravel surface, lower

runners so the housing will not pick up gravel. On

concrete, blacktopped or packed down snow surfaces,

raise runners so that scraper blade scrapes clean.

Position unit on a flat level surface. Adjust runners by

inserting a spacer of desired thickness under center of

scraper blade, loosen hardware, slide runners to flat

surface and retighten hardware.

NOTE: Above method keeps housing level by adjust-

ing runners equally. Uneven runners make machine

difficult to steer and results in uneven clearing.

Figure 25

CAUTION: Adjust auger/impeller housing

height to clear gravel or crushed rock

surfaces.

1. Runner

2. Scraper

1 2 ... 25 26 27 28 29 30 31 32 33 34

No comments

Ariens 932 Series Service Manual Page 30