Ariens 932 Series Service Manual download pdf (Page 20)

5 - 20

5.5 TRACTION DRIVE CLUTCH

ADJUSTMENT

If drive slips, adjust traction clutch to compensate for

friction disc wear.

To test traction clutch (Figure 14):

1. Put unit in first forward speed.

2. Without engine running, push unit forward while

slowly moving the traction drive clutch lever toward

the handle grip.

3. Measure distance between lever and handlebar

when the wheels brake. If distance is not 6–1/8

in.

± 1/4

in. (15.5 cm ± 6 mm), adjust the traction

clutch.

Figure 14

To adjust traction clutch (Figure 15):

1. Loosen jam nut on traction cable adjustment

barrel.

2. Turn the adjustment barrel up the cable to

decrease the distance between clutch lever and

handlebar.

3. Turn the adjustment barrel down the cable to

increase the distance between clutch lever and

handlebar.

4. Check traction clutch lever distance and repeat

adjustment steps if necessary.

5. Tighten jam nut on traction cable adjustment

barrel.

Figure 15

5.6 SPEED SELECTOR ADJUSTMENT

Figure 16

To adjust (Figure 16):

1. Remove hair pin from adjustment pivot pin.

2. Pull shift rod and adjustment pivot pin out of speed

selector lever.

3. Place the speed selector in the fastest forward

speed position.

4. Pull the shift rod straight down towards the ground

as far as it will go.

5. Thread the adjustment pivot pin along the shift rod

until it aligns with the mating hole on the speed

selector lever.

6. Reinsert the pivot pin into the hole on the speed

selector lever.

7. Check forward and reverse speeds.

a. Start unit.

b. Shift speed selector into first forward speed.

c. Engage traction clutch. Unit should move

forward.

d. Stop unit.

e. Shift speed selector into first reverse speed.

f. Engage traction clutch. Unit should move

backward.

g. Shut off unit.

8. Adjust pivot pin as needed so unit travels forward

when speed selector lever is in first forward

position and backward when speed selector lever

is in first reverse position.

9. Secure adjustment pivot pin to speed selector lever

with hairpin.

6-1/8 ± 1/4 in

(15,5 cm ± 6 mm)

Traction Drive

Clutch Lever

OS0457

1. Traction Clutch Cable

2. Adjustment Barrel

3. Jam Nut

4. Speed Selector Arm

5. Shift Rod

OS6825

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector

Lever

PS0703

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 20

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series