Ariens 932 Series Service Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
9 - 26
9.1 FRICTION DISC REPLACEMENT
Remove (Figure 21)
1. Shut off engine, remove key, disconnect spark plug
wire, and allow unit to cool completely.
2. Place unit on a level surface and tip unit up onto
front housing.
3. Remove wheels.
4. Remove bottom cover.
NOTE: The following may be easier if the pinion shaft
is removed. See Section 8 - Reduction Drive.
5. Disconnect shift rod from speed selector arm.
6. Carefully tap roll pins out of hex shaft.
7. Remove outside bearing flange and bearing from
each side of unit.
8. Remove friction disc from shift carrier.
9. Remove roller chain from sprocket on hex shaft.
10.Remove spacer from hex shaft.
11.Hold shift carrier and slide hex shaft slowly to the
right.
12.Slide shaft only far enough to remove the old
friction disc from hex shaft.
Install
1. Place flat side of new friction disc against shift
carrier.
2. Hold shift carrier, slide hex shaft back toward the
left through roller chain and spacer, and through
the opening in the side of the unit.
Figure 21
3. Install roller chain on sprocket teeth of hex shaft.
4. Install bearings and outside bearing flanges.
5. Bolt new friction disc to shift carrier. Tighten
hardware to 5-6 lbf-ft (6.8 to 8.13
Nm).
6. Install roll pins in hex shaft. Ensure roll pins are
centered in hex shaft.
7. Install shift rod on speed selector arm.
8. Install bottom cover.
9. Install wheels.
10.Set unit upright.
11.Install spark plug wire on spark plug.
12.Adjust speed selector lever.
9.2 FRICTION WHEEL CARRIER
The friction wheel carrier is not repairable and is
replaced when needed. Inspect the carrier when the
friction wheel is serviced.
SECTION 9 - FRICTION WHEEL DRIVE
CAUTION: Remove fuel from fuel tank prior
to placing unit in service position.
1. Roller Chain
2. Roll pin
3. Hex Shaft
4. Friction Disc
5. Speed Fork
6. Shift Carrier
7. Outside Bearing
Flange
8. Ball Bearing
9. Inside Bearing
Flange
10.Spacer
1
2
3
4
5
6
7
8
9
5
6
43
10
98
7
2
2
OS5000
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments