Ariens 916003 - AMP 24 Specifications Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
GB - 11
.
Charge Batteries
The batteries MUST be charged for a
minimum of 7 hours before the first use.
See Pre-Start on page 15.
IMPORTANT: The unit MUST be connected
to the battery charger whenever it is not in
use. Failure to keep batteries fully charged
will reduce battery life and void battery
warranty.
Check Function of Dual Handle
Interlock
With power switch in the off position, press
down (engage) both clutch levers. Release
pressure on attachment clutch (right side)
lever. The attachment clutch should remain
engaged until traction clutch lever is
released, then both clutches must disengage.
If they do not, contact your Dealer for repairs.
Check Tire Pressure
Check tire pressure and adjust to the
pressure listed on tire sidewall.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Check
Auger Gearcase on page 19).
Check Function of all Controls
Ensure unit runs and performs properly. Refer
to Operation.
Run-in Attachment Belt
1. Run unit according to Starting and Shut
Off on page 17.
2. Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to
stop, and remove key.
4. Adjust clutch idler according to
Attachment Clutch/Brake Adjustment on
page 25.
1. Upper Mounting
Hole
2. Snap Fitting
3. Rubber Seal
Cap
4. Hairpin
5. Washer
6. Cable Eye
2
1
3
4
6
5
Figure 9
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
Do not attempt to mount a tire
without the proper equipment
and experience to perform the
job.
Do not inflate the tires above
the recommended pressure.
Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or deform
the wheel.
Do not stand in front or over
the tire assembly when
inflating. Use a clip-on chuck
and extension hose long
enough to allow you to stand
to one side.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments