Ariens 916003 - AMP 24 Specifications download pdf (Page 22)

GB - 22

REMOVING AND INSTALLING

BATTERIES

Removal

1. Move power and PTO switches to the

OFF position. Remove key from switch.

2. Remove four screws securing battery

cover to unit and rotate battery cover

toward handlebar. Use care not to place

excess tension on wires.

3. Disconnect batteries from unit power

harness.

4. Carefully lift batteries from battery box.

Installation

Figure 22

1. Install the rear battery into battery box

standing upright with wire leads in the

top left position.

2. Insert the front battery on its side into the

battery box with the wire leads oriented

toward the top left position.

3. Connect batteries to power cable.

4. Install battery cover.

SPEED SELECTOR

ADJUSTMENT

To adjust (Figure 23):

1. Disconnect adjustment pivot pin from

speed selector arm. Save hardware for

reinstallation.

2. Place the speed selector on dash panel

in the fastest forward (6) speed position.

3. Turn the speed selector arm straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector arm, and

then turn it up the shift rod 3 turns. Insert

the pivot pin into hole.

5. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

6. Check forward and reverse speeds:

a. Move power and PTO switches to

the ON position.

b. Shift speed selector into the first

forward speed.

c. Engage the traction clutch. Unit

should move forward.

d. Release the traction clutch.

e. Shift speed selector into first

reverse speed.

f. Engage the traction clutch. Unit

should move backward.

g. Shut off unit.

7. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

8. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

NOTE: If first forward speed is too fast,

disconnect adjustment pivot pin from speed

selector arm. Rotate pivot pin to move it up

the shift rod a maximum of 2 turns and

reconnect pivot pin to speed selector arm.

Figure 21

OS2620

1. Spring

2. Nut

1

2

Figure 22

Front

1. Rear Battery

2. Front Battery

3. Wire Leads

1

2

3

3

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments