Ariens 916003 - AMP 24 Specifications download pdf (Page 28)

GB - 28

FRICTION DISC REPLACEMENT

Remove Friction Disc

Figure 36

1. Move PTO and power switches to OFF

position. Remove key.

2. Disconnect and remove batteries.

3. Place the unit into the service position

on a level surface (see Service Position

on page 18).

4. Remove lockpins from wheel axles and

remove wheels.

5. Remove bottom cover by removing six

hex bolts.

6. Disconnect pivot pin from the speed

selector arm. Save the hardware for

reinstallation.

7. Remove spring clip pin nearest drive

gear from hex shaft.

8. Remove left bearing flange from frame.

9. Slide hex shaft to the left to remove the

flat washer, pinion gear and friction disc

assembly from the hex shaft.

NOTE: Be sure to save washers between

bearing and sliding fork for reassembly.

10. Remove friction disc assembly from

frame.

11. Remove three screws holding friction

disc to carrier bearing.

12. Remove old friction disc. Put the new

friction disc in place, cup side to carrier

bearing.

13. Reinstall three screws into new friction

disc and carrier bearing. Torque to

5 – 6 lbf-ft. (6.8 – 8.13 N•m).

14. Insert new friction disc assembly into

frame. Install washers onto carrier

bearing and slide into speed selector

arm.

15. Slide hex shaft through new friction plate

assembly. Install pinion gear and washer

onto hex shaft and slide shaft into right

bearing.

16. Install left bearing using hardware

removed in step 8.

17. Reinstall clip pin into hex shaft.

CAUTION: Before tipping unit up

onto housing, both batteries must be

removed from the unit. Ensure unit is

secure and will not tip over during

maintenance.

Figure 35

1. Traction Drive

Clutch Cable

2. Adjustment

Barrel

3. Jam Nut

OS2665

1

2

3

1. Hex Shaft

2. Friction Disc

Assembly

3. Left Bearing

Flange

4. Speed

Selector

Arm

5. Friction Disc

6. Right

Bearing

Flange

7. Carrier

Bearing

8. Spring Clip

9. Drive Gear

10. Drive Plate

Assembly

OS8095

Figure 36

1

2

3

4

6

7

5

8

9

10

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments