Ariens 916003 - AMP 24 Specifications download pdf (Page 16)

GB - 16

4. Plug battery charger into wall outlet. Do

not use an extension cord unless

necessary. If an extension cord is

needed follow the manufacturer’s

recommendations for length and

capacity.

Ensure that status indicator LEDs are lit on

charger (see Figure 14). If LEDs do not light

correctly refer to troubleshooting chart (see

BATTERY CHARGING

TROUBLESHOOTING on page 31).

5. Allow batteries to charge. When fully

charged the green "READY" LED on the

charger will light. Do not disconnect

battery charger until the Sno-Thro is to

be used.

NOTE: Depending on extent of discharge

and battery condition, allow approximately 7

hours for a complete recharge before

additional use.

NOTE: An optional heavy duty charger is

available that reduces charge time to

approximately 3 hours (see ACCESSORIES

on page 31).

6. To use Sno-Thro, disconnect battery

charger from wall outlet and disconnect

from unit charging port. Store charger in

a dry area away from children, pets, heat

and moisture.

1. Check Function of Clutches

If clutches do not engage or disengage

properly, adjust or repair before operation.

See Attachment Clutch/Brake Adjustment on

page 25 and Traction Drive Clutch

Adjustment on page 27.

Figure 13

1. Battery Charger Connector

2. Battery Charging Port

1

2

Figure 14

ON: (Power) – Red LED

remains lit while battery

charger is attached to unit and

plugged into outlet. Flashes

once per second when in

hibernation mode.

CHARGE: Yellow LED

remains lit while batteries are

charging, begins to flash when

batteries reach 80% charge

level, and continues to flash

until full charge is achieved.

Shuts off upon full charge.

READY: Green LED lights

and remains lit once batteries

are fully charged.

Connector

Battery Charger

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments