Ariens 916003 - AMP 24 Specifications download pdf (Page 19)

GB - 19

CHECK CLUTCH OPERATION

Auger and impeller must stop within 5

seconds when attachment clutch/impeller

brake lever is released.

Wheels must stop quickly when traction drive

clutch lever is released.

If clutches do not engage or disengage

properly, adjust or repair before operation

(see Attachment Clutch/Brake Adjustment on

page 25 and Traction Drive Clutch

Adjustment on page 27).

CHECK CLUTCH SPRING

ADJUSTMENT

Make sure the attachment clutch and traction

drive clutch are adjusted to the range

specified in Attachment Clutch/Brake

Adjustment on page 25 and Traction Drive

Clutch Adjustment on page 27.

CHECK TIRE PRESSURE

Keep tires at pressure listed on the tire

sidewall. (see Check Tire Pressure on

page 11).

CHECK AUGER GEARCASE

IMPORTANT: Proper oil level must be

maintained.

Gear cases are filled to the correct level at

the factory. Unless there is evidence of

leakage, no additional lubricant should be

required. Check oil level each season or

every 25 hours of operation.

To ensure adequate lubricant level:

1. Remove filler plug (Figure 16). Lubricant

must be at least up to bottom of lubricant

filler hole with unit resting on a level

surface.

2. Add lubricant if required. Allow oil to

drain to level of plug and replace plug.

IMPORTANT: Use only Ariens special gear

lubricant L-2 (Part Number 00008000).

Gearcase filler plug may require an

application of Loctite® 565 thread sealant

with repeated servicing.

GENERAL LUBRICATION

Figure 17

IMPORTANT: Wipe each fitting clean before

and after lubrication. Do not wipe gearcase

filler plug; wiping the gearcase filler plug may

remove thread sealant and cause leaks.

IMPORTANT: DO NOT allow grease or oil to

get on friction disc, friction plate or belts.

NOTE: Apply Ariens Hi-Temp Grease or

equivalent to the lubrication fittings. See

SERVICE PARTS on page 31.

Sno-Thro should be lubricated (Figure 17) at

beginning of season or every 25 operating

hours.

Auger Shaft

NOTE: To grease auger shaft, remove shear

bolt nuts, and shear bolts. Apply grease at the

grease zerks and then turn the auger

assemblies on the auger shaft. Replace

shear bolts per instructions in Shear Bolts on

page 21.

Figure 16

1. Auger Gearcase

2. Filler Plug

OS2600

1

2

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments