Ariens 916003 - AMP 24 Specifications download pdf (Page 18)

GB - 18

TRANSPORT

ALWAYS move PTO and power switches to

OFF position and remove key when

transporting unit on a truck or trailer.

Use extra care when loading or unloading

unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

Ariens Dealers will provide any service or

adjustments which may be required to keep

your unit operating at peak efficiency.

SERVICE POSITION

Remove hair pin from chute crank and

remove chute crank arm. Remove both

batteries and place unit on a flat level surface

(see Removing and Installing Batteries on

page 22). Tip unit forward onto front of auger

housing for service. Ensure unit is secure and

will not tip over. Strap and clamp onto bench if

needed.

MAINTENANCE SCHEDULE

The chart below shows the recommended

maintenance schedule that should be

performed on a regular basis. More frequent

service may be required.

* Batteries MUST be connected to battery

charger after every use, regardless of length

of time unit was operated. After batteries are

charged the battery charger must remain

connected until the next use. Failure to keep

batteries fully charged will reduce battery life

and void battery warranty.

CHECK DUAL HANDLE

INTERLOCK

Check operation of dual handle interlock. See

Dual Handle Interlock on page 13.

CHECK FASTENERS

Make sure all hardware is tightened properly.

MAINTENANCE

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: Before tipping unit up

onto housing, both batteries must be

removed from the unit. Ensure unit is

secure and will not tip over during

maintenance.

Figure 15

Service Position

OS2595

Batteries MUST be

removed before

tipping unit.

MAINTENANCE SCHEDULE

Service

Performed

Each

Use

Every

5 hrs.

Every

25

hrs.

Yearly

Charge

Batteries *

•

Check Dual

Handle

Interlock

•

Check

Fasteners

•

Check Clutch

Operation

•

Check Clutch

Spring

Adjustments

•

Check Tire

Pressure

••

Check Auger

Gearcase

••

General

Lubrication

••

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments