Ariens 992808-ProZoom 3166S Specifications Page 9
- Page / 76
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
GB - 9
Do not attempt to service a tire unless you have the proper
equipment and experience to perform the job. If you are not
qualified to make the repairs, take the unit to your Ariens
dealer or a qualified repair service.
When seating tire beads on the rims, never exceed 2, 4 bar
(35 p.s.i.) or the maximum inflation specified on your tires.
Inflation beyond this maximum pressure may break the
bead, or even the rim, with dangerous explosive force.
Replacement Parts
Where replacement parts are necessary for periodic
maintenance and servicing, genuine Ariens replacements
must be used.
Ariens does not claim responsibility for installation of
unapproved parts and/or accessories or damages as a
result of their use.
UNPACK UNIT
Remove all packing materials and hardware and literature
packages. Discard J hook used with strapping as it is not
needed for mower operation.
SETUP INSTRUCTIONS
Ariens mowers are shipped partially assembled. After
uncrating the power unit and mower deck, initial setup is
required.
IMPORTANT: During the unpacking of the crate all goods
should be matched against the packing list and all shortages
or damages should be noted and reported to the carrier
immediately.
Steering Controls
1. The steering control levers may have been loosened
and moved forward for shipping. Remove the loose
3/8-16 x 1.75" bolts from the handles and reinstall
them in the location shown. Adjust the handles to fit
your comfort area.
Seat Setup
1. Remove the loose 3/8" clevis pin, flat washers and rue
ring from the manual pack.
2. Carefully rotate the seat back far enough to install the
seat lock lever in the location shown in figure 3.
3. Connect the seat lock lever, figure 4, to the seat plate
using the 3/8" clevis pin, two 3/8" flat steel washers
and the rue ring.
Battery
The battery supplied with the mower is sealed, it will not be
necessary to activate it.
1. Connect the red positive cable to the positive (+) side
of battery. Use 1/4 x 5/8" bolt and 1/4" locknut. Cover
terminal with rubber boot.
2. Connect the black negative cable to Negative ( - ) side
of battery. Use 1/4 x 5/8" bolt and 1/4" locknut.
If the engine does not turn over by turning the ignition
switch, it may be necessary to charge the battery. (See
Charging the Battery on page 22.)
Deck
1. Remove knob from discharge shield.
2. Remove discharge assembly from Transport position.
3. Install discharge assembly in Operating position.
4. Reinstall knob in discharge assembly and tighten.
ASSEMBLY
WARNING: AVOID INJURY! Read and
understand entire Safety Section before
proceeding.
Figure 3
Install
Bolt
Here
Figure 4
Seat Lock Lever
- Owner/Operator Manual 1
- TABLE OF CONTENTS 2
- INTRODUCTION 2
- PRACTICES AND LAWS 4
- REQUIRED OPERATOR TRAINING 4
- SAFETY DECALS AND LOCATIONS 4
- SAFETY RULES 5
- MAINTENANCE AND STORAGE 6
- MOWER SAFETY 6
- GENERAL SAFETY RULES 6
- MAINTENANCE 7
- Hydraulic System 8
- Battery Maintenance 8
- Tire Maintenance 8
- Fuel System 8
- ASSEMBLY 9
- CONTROLS AND FEATURES 11
- 07757600B 12
- PTOP T O 12
- PARK BRAKE 13
- U.S. PAT. NO. 6,434,917 B1 13
- OPERATION 14
- PRE-START INSPECTION 14
- STARTING AND SHUT OFF 15
- Side-Discharge Mowers 16
- Uneven Terrain 16
- Grass Discharge 16
- Tips For Efficient Mowing 16
- MAINTENANCE SCHEDULE 17
- Interval Task Action 18
- ADDADD FULLFULL 19
- HYDRAULIC SYSTEM MAINTENANCE 20
- BATTERY MAINTENANCE 21
- CHARGING THE BATTERY 22
- LIFT ASSIST SPRING 23
- NEUTRAL ADJUSTMENT 23
- LEVELING THE DECK 23
- DRIVE ADJUSTMENTS 24
- FUEL SYSTEM SERVICE 25
- SPARK PLUG SERVICE 26
- COOLING SYSTEM CLEANING 26
- TIRE AND WHEEL SERVICE 27
- BLADE MAINTENANCE 27
- SHORT TERM 29
- LONG TERM 29
- TROUBLESHOOTING 30
- ACCESSORIES 33
- SERVICE PARTS – MOWER 33
- SERVICE PARTS – TRACTOR 33
- SPECIFICATIONS 34
- Two-Year Limited Lawn and 36
- Garden Commercial Warranty 36
- Limitations 37
- Disclaimer 37
- TABLE DES MATIÈRES 38
- ENREGISTREMENT DE PRODUIT 39
- DÉNI DE RESPONSABILITÉ 39
- À LA LIVRAISON 39
- SÉCURITÉ 40
- CONSIGNES DE SÉCURITÉ 41
- ENTRETIEN ET REMISAGE 42
- ENTRETIEN 44
- Alimentation à essence 45
- Circuit hydraulique 45
- Entretien de la batterie 45
- TRANSPORT 46
- DÉBALLAGE DE LA MACHINE 46
- COMMANDES ET CARACTÉRISTIQUES 48
- FONCTIONNEMENT 49
- ARRÊTMARCHE 50
- INSPECTION AVANT DE COMMENCER 52
- MISE EN MARCHE ET ARRÊT 52
- Roue anti-scalp 53
- Terrains inégaux 53
- STATIONNEMENT 54
- PÉRIODICITÉ DE L’ENTRETIEN 55
- Intervalle Tâche Action 56
- Vidange de l’huile moteur 58
- Vidange du fluide hydraulique 58
- ENTRETIEN DE LA BATTERIE 59
- CHARGE DE LA BATTERIE 60
- ROULETTES 61
- RESSORT D’AIDE AU LEVAGE 61
- RÉGLAGE DU POINT MORT 61
- DE DIRECTION 62
- DE COUPE 62
- RÉGLAGE DE L’ENTRAÎNEMENT 63
- (FIGURE 21) 63
- ENTRETIEN BOUGIE 64
- NETTOYAGE DU CIRCUIT 65
- DE REFROIDISSEMENT 65
- ENTRETIEN DE LA LAME 65
- DU CARTER DE COUPE 67
- COURROIES 67
- REMISAGE 68
- DÉPANNAGE 69
- ACCESSOIRES 72
- PIÈCES DE RECHANGE - TONDEUSE 72
- PIÈCES DE RECHANGE – 72
- GROUPE MOTEUR 72
- CARACTÉRISTIQUES 73
- Garantie commerciale 74
- Déni de responsabilité 75
Related products and manuals for Lawnmowers Ariens 992808-ProZoom 3166S
Lawnmowers Ariens 3ML6D-12001 User Manual
(51 pages)
(51 pages)
Lawnmowers Ariens A149K21 Owner's Manual
(20 pages)
(20 pages)
Lawnmowers Ariens 475 User Manual
(36 pages)
(36 pages)
Lawnmowers Ariens 911173 Specifications
(30 pages)
(30 pages)
Lawnmowers Ariens 936048 User Manual
(21 pages)
(21 pages)
Lawnmowers Ariens 996148 Specifications
(42 pages)
(42 pages)
Lawnmowers Ariens 915131-1334 Specifications
(57 pages)
(57 pages)
(68 pages)© 2020, manymanuals.com. All rights reserved. | 0.778 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals