Ariens 992808-ProZoom 3166S Specifications Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
GB - 26
SPARK PLUG SERVICE
Clean or replace the spark plug and reset the gap every 100
hours of operation.
1. Disconnect the spark plug wire lead and remove the
spark plug.
2. Clean the electrodes by scraping with a wire brush to
remove carbon deposits.
3. Inspect for cracked porcelain or other wear and
damage. If any wear or damage is evident, replace
with a new spark plug.
4. Check the spark plug gap and reset if necessary. The
correct gap should be .030 inches (.75 mm). To
change the gap, bend only the side electrode using a
spark plug tool.
5. Install and tighten the spark plug to 22 N·m (16 ft. lbs.).
Reconnect the spark plug wire lead.
See the engine operator’s manual for the recommended
spark plug.
COOLING SYSTEM CLEANING
Before each use check to make sure the air intake screen is
free from grass and debris and clean if necessary.
Every 100 hours of operation, check and clean the cooling
fins and inside the engine shrouds to remove grass, chaff or
dirt clogging the cooling system and causing overheating.
WARNING: Hot engine components can cause
severe burns. Stop engine and allow it to cool
before checking the spark plug.
LH Rear View
Figure 22
OE3336
Hose Clamps
Fuel Filter
Figure 23
Spark Plug Wire
OE3341
CAUTION: Do not run the engine before all
cooling system parts are reinstalled to keep the
cooling and carburetion as intended.
1
2
Figure 24
.030 in.
(.75mm)
1. Center Electrode Insulator
2. Side Electrode
3. Air Gap (Not to Scale)
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 75 76

Comments to this Manuals

No comments