Ariens 992808-ProZoom 3166S Specifications Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
GB - 16
Side-Discharge Mowers
The mower has a pinned discharge shield that discharges
the clippings out of the side of the deck and onto the ground.
Uneven Terrain
Pre-plan mowing over uneven terrain so the grass will be
dry, minimizing wheel slippage and spinning, which will
damage the turf.
Before mowing, check the area to determine the best
procedure. Consider the grass type and height, and the type
of uneven terrain on which the mowing is to take place.
Avoid sudden starts and stops while traveling up or down
incline, and slow the ground speed while turning.
Grass Discharge
The mower deck has been designed to provide maximum air
flow for an even discharge of grass clippings. When mowing
tall, or lush grasses, select a lower mower ground speed, or
reduce the width of cut, for the best discharge efficiency.
For the best lawn appearance, do not mow when the grass
is wet or heavy with dew. Wet grass could plug the discharge
area of the mower, create an unnatural load on the blades
and spindles, and damage the mower deck belt. Wet grass
will also leave unsightly clumps on the lawn.
If the mower deck becomes clogged, back the unit out of the
uncut grass. If the mower will not clear itself, raise the deck,
shut off the engine, set the brake, remove the ignition key
and clean the bottom of the deck.
In medium and heavy cutting conditions, mow so the
discharged clippings will be AWAY from the uncut grass. In
light cutting, discharged clippings can be directed onto the
uncut grass, allowing them to be recut finer.
Tips For Efficient Mowing
Mowing blades should be checked regularly and kept sharp
to ensure the best lawn appearance.
Best results occur normally when the grass is maintained at
a height of 2–3 inches (50–80mm). It is best to cut the grass
often and not too short. To keep a healthy green lawn, do not
cut more than 1/3 of the overall grass blade height.
Mower engine speed while mowing should be at the
maximum rated RPM. This will ensure proper blade speed
for effective cutting and discharge of grass clippings.
Travel speed greatly affects mowing performance. Always
use a lower ground speed for slower mowing, rather than
lowering the engine RPM.
Mow often. Do not wait for the grass to get too tall. Short
grass clippings will disperse better and deteriorate faster.
Mowing areas with tall grass or weeds may require cutting at
maximum height of cut. After mowing once, recut the entire
area with the mower reset to the desired final height of cut.
PARKING
To park the unit:
1. Bring the steering levers to neutral and then push them
out to the park position.
2. Turn off the PTO, stop the engine, lower the deck to
the ground and remove the ignition key.
IMPORTANT: When parking on any slope, be sure to chock
the wheels on the downhill side to prevent the unit from
sliding.
DANGER: Without the discharge shield or a
complete grass collector installed, you and
others are exposed to rotating mower blades
and thrown debris. Contact with the mower
blades or flying debris could cause severe injury
or death.
The discharge deflector routes material down
toward the ground. Never remove the discharge
shield or operate the mower with a damaged
discharge deflector.
Never put your hands or feet under the mower.
Do not try to clear the mower discharge area or
mower blades without first turning the mower
PTO to off, turning the ignition key to off,
removing the key and disconnecting the battery
cable.
WARNING: To avoid the loss of control and to
prevent overturning the mower, always across
slopes, never up and down.
Pass diagonally through sharp dips. Avoid sharp
drop offs completely to prevent the mower from
becoming hung up.
Keep the power unit steering control levers
forward when going downhill.
WARNING: NEVER operate the mower with
the discharge shield in the raised position.
CAUTION: Clear the area of people, pets, and
all visible debris before beginning mowing
operations.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Comments to this Manuals

No comments