Ariens Platinum 30 Specifications download pdf (Page 29)

EN - 29

SPEED SELECTOR ADJUSTMENT

(Figure 32)

To adjust:

1. Disconnect adjustment pivot pin from

speed selector lever by removing

hairpin.

2. Place the speed selector on the control

panel in the fastest forward speed

position.

3. Turn the speed selector lever straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector lever. Insert

the pivot pin into hole.

5. Secure adjustment pivot pin with hairpin.

6. Make sure the speed selector shifts into

each speed position.

7. Check forward and reverse speeds:

a. Start unit.

b. Shift speed selector into the first

forward speed.

c. Engage the traction drive clutch.

Unit should move forward.

d. Stop unit.

e. Shift speed selector into first

reverse speed.

f. Engage the traction drive clutch.

Unit should move backward.

g. Shut off unit.

8. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

9. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

ATTACHMENT CLUTCH/BRAKE

ADJUSTMENT

(Figures 33 and 34)

Remove Attachment Cable Slack

1. Shut off engine, remove key, disconnect

spark plug wire and allow unit to cool

completely.

2. Loosen hardware securing belt cover to

unit.

NOTICE: DO NOT completely remove the

hardware from unit.

3. Remove belt cover.

4. Loosen jam nut on cable adjustment

barrel, and then turn the adjustment

barrel down to shorten cable and

remove all cable slack (Figure 33).

5. With the attachment clutch disengaged,

check that the attachment idler arm

lightly touches the frame (Figure 34).

6. Tighten jam nut on the adjustment

barrel.

Figure 32

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector Lever

4. Hairpin

2

3

1

4

OS7186

IMPORTANT: IMPROPER

ADJUSTMENT could result in

unexpected movement of auger and

impeller causing death or serious

injury. Auger/Impeller must stop

within 5 seconds when Attachment

Clutch lever is released.

Figure 33

1. Adjustment Barrel

2. Jam Nut

2

1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Comments to this Manuals

No comments