Ariens Platinum 30 Specifications download pdf (Page 32)

EN - 32

Install New Attachment Drive Belts:

1. Place new attachment belts onto

attachment pulley.

NOTICE: Holding down the attachment clutch

lever will make it easier to reconnect the

housing and frame.

2. Tip housing and frame back together

and secure with hex bolts.

3. Place belts onto engine sheave.

4. Reposition and secure belt finger.

IMPORTANT: With attachment clutch lever

engaged, belt finger on the side opposite the

belt idler should be less than 1/8" (3 mm)

from belt, but not touching the belt. Adjust

belt finger as necessary.

5. Check adjustment. See Attachment

Clutch/Brake Adjustment on page 29.

6. Reconnect chute lock cable, chute

deflector cap cable, chute crank and

secure.

7. 921028, 029 – Reinstall chute gear

cover.

8. Replace belt cover and tighten

hardware.

TRACTION DRIVE BELT

REPLACEMENT

NOTICE: Replacement will be easier with

housing and frame tipped apart and bottom

cover off.

1. Remove attachment drive belts (see

Remove old attachment drive belts: on

page 31).

2. Detach traction idler spring.

3. Remove swing gate spacer and slide

drive plate over so that finger clears stop

hole in frame and can swing past it

(Figure 40).

NOTICE: The drive plate is detached to

create space between the drive plate and

friction disc to remove and reinstall the belt.

Figure 38

921023, 024, 030, 032, 035

921028, 029

1. Belt Cover

2. Chute Gear Cover

3. Discharge Chute Rod

4. Chute Lock Cable

1

2

3

4

1

3

2

WARNING: AUGER / IMPELLER

MUST STOP within 5 seconds

when attachment clutch lever is

released or unit damage or serious

injury may result.

Figure 39

1. Traction Drive Belt

2. Engine Sheave

3. Attachment Drive Belts

4. Belt Finger

5. Attachment Belt Idler

6. Attachment Idler Adjustment Nut

7. Traction Belt Idler

2

1

3

4

5

6

7

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Comments to this Manuals

No comments