Ariens Platinum 30 Specifications Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
EN - 13
NOTICE: To ensure the discharge chute
follows its full range of travel, make sure the
control lever is centered in the slot and
pointing straight up before installing the chute
rod.
9. Insert chute rod end without ears into
control lever and slide into control panel
until opposite end of rod clears the gear
assembly.
10. Align end of chute rod with hex hole in
gear assembly and insert until ears hit
gear.
11. Insert hairpin into hole in chute rod near
gear assembly.
12. Hook the chute control cable onto the
chute rod.
IMPORTANT: The chute control cable hook
will prevent the cable from contacting the
engine or muffler guard. Make sure this cable
stays connected while unit is in operation.
13. Check to make sure the chute control
cable ends are properly seated in control
assembly and lock arm.
14. Adjust control cable as necessary to
remove cable slack. Be sure lock arm is
fully seated in gear teeth.
15. Replace gear cover on top of chute
pedestal.
16. Orient the chute and pedestal to its most
vertical position and tighten pedestal
hardware to 15 – 31 lbf-ft (20 – 42 N•m).
17. Make sure the discharge chute rotates
left and right when you push the
discharge chute control lever left and
right.
NOTICE: If chute does not stay in position,
adjust as directed in Discharge Chute
(921028, 029) on page 28 or repair before
operation.
Remote Deflector Control
(Figure 15)
NOTICE: Connect the barrel cable end to the
chute deflector cable anchor before clipping
the cable to the discharge chute cable
bracket.
1. Route deflector cable along the left side
of the chute pedestal.
2. Insert the barrel cable end into the
bracket on left side of chute deflector
(Figure 15).
3. Hold seal out of the way while routing
the cable through the bracket on the left
side of the discharge chute, and then
push the cable fitting into the bracket.
4. Push the seal securely over the end of
the cable fitting to prevent water from
entering the cable.
5. Check deflector travel. Adjust nut on
cable end under control panel to obtain
full travel, if necessary (see Remote
Deflector Control Adjustment on
page 28)
.
Figure 15
1. Chute Deflector Cable Anchor
2. Barrel Cable End
3. Deflector Cable
4. Cable Fitting
5. Discharge Chute Cable Bracket
1
2
3
5
4
3
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Comments to this Manuals

No comments