Ariens Platinum 30 Specifications download pdf (Page 20)

EN - 20

Skid Shoes

The skid shoes control the distance between

the scraper blade and the ground. Adjust skid

shoes equally to keep blade level with the

ground. Refer to Pre-Start on page 21 for

recommended settings.

Track Angle

(921023)

(Figure 23)

The track angle can be adjusted to position

the auger housing for level clearing, deep

cutting or transport.

Squeeze the handlebar trigger and press

down on the handlebars to move the auger

housing into an up position. Release the

trigger to hold the position.

Squeeze the handlebar trigger and lift up on

the handlebars to move the auger housing

into a down position. Release the trigger to

hold the position.

FILLING FUEL TANK

GASOLINE

IMPORTANT: ALWAYS use gasoline that

meets the following guidelines:

• Clean, fresh gasoline.

• A minimum of 87 octane/87 AKI (91

RON). High altitude use may require a

different octane. Consult your engine

manual.

• Gasoline with up to 10% ethanol

(gasohol) or up to 10% MTBE (methyl

tertiary butyl ether) is acceptable.

• Use of any gasoline other than those

approved above will void the engine

warranty. If the pumps are not marked

for the content of alcohol or ethers,

check ethanol and MTBE levels with

the fuel supplier.

• Do not modify the fuel system to use

different fuels.

• Never mix oil and gasoline.

NOTICE: All gasoline is not the same. If the

engine experiences starting or performance

problems after using a new gasoline, switch

to a different fuel provider or fuel brand.

IMPORTANT: Excessively oxygenated or

reformulated fuels (fuels blended with

alcohols or ethers) can damage the fuel

system or cause performance problems. If

any undesirable operating problems occur,

use a gasoline with a lower percentage of

alcohol or ether.

Add Fuel Stabilizer to

Extend Fuel Storage Life

IMPORTANT: Fuel stabilizer is recommended

for extended storage (see Fuel System on

page 35)

Add Fuel to Fuel Tank

1. ALWAYS place unit in open or well-

ventilated area.

2. Stop engine and allow to cool.

3. Clean Fuel Cap and surrounding area to

prevent dirt from entering Fuel Tank.

4. Remove fuel cap.

IMPORTANT: Refer to Engine Manual for

correct type and grade of fuel.

5. Fill fuel tank to the bottom of filler neck.

See SPECIFICATIONS on page 37 for

fuel tank capacity.

Figure 23

Deep Cutting

OS7111

Transport

Normal

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Comments to this Manuals

No comments