Ariens Platinum 30 Specifications download pdf (Page 23)

EN - 23

Shut Off

1. Release Traction Drive Clutch Lever and

allow unit to come to a complete stop.

2. Run Impeller a few minutes after use to

prevent freeze-up of Impeller.

3. Release Attachment Clutch Lever and

wait for all moving parts to come to a

complete stop.

4. Move Throttle to the “Slow” position.

5. 921023, 035: Turn ignition key into the

"Stop" position and remove key.

921024, 028, 029, 030, 032: Turn off the

engine shut-off switch ("STOP").

SNOW REMOVAL

IMPORTANT: Allow unit and engine to adjust

to the outdoor temperature before clearing

snow.

NOTICE: Attachment clutch should be

engaged before traction drive clutch when

throwing snow.

1. Select Speed Control position and

direction.

2. Engage Attachment Clutch – Right Hand

Lever.

3. Engage Traction Drive Clutch – Left

Hand Lever.

IMPORTANT: DO NOT overload unit capacity

by attempting to clear snow at too fast a rate.

Use slow speed to clear deep or hard packed

snow.

Tips for Operation

Snow is best removed as soon as possible

after snow fall.

To clear an area, run unit in an overlapping

series of paths. For large areas, start in the

middle and throw snow to each side, so snow

is not cleared more than once.

ALWAYS direct snow away from area to be

cleared and with direction of the wind.

TRAVELING

To travel from one work area to another:

1. Set Throttle to Slow or Part-Throttle

position.

2. 921024, 028, 029, 030, 032, 035: Press

down on handlebars enough to raise

front of unit slightly off surface.

921023: Place the unit in the transport

position (see Track Angle on page 20)

3. Engage traction drive clutch lever

without engaging attachment drive

clutch.

TRANSPORT

ALWAYS shut off engine, remove key, and

close fuel shut-off valve when transporting

unit on a truck or trailer.

Use extra care when loading or unloading

unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

DO NOT transport machine while engine is

running.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Comments to this Manuals

No comments