Ariens Platinum 30 Specifications Page 22
- Page / 42
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
EN - 22
STARTING AND SHUT OFF
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperature before clearing
snow. Before shut-off, run the attachment a
few minutes to prevent impeller freeze-up.
NOTICE: Try out each control without the
engine running to see how it works and what
it does.
Manual Start
1. Turn discharge chute straight ahead.
2. Make sure that the attachment clutch
and traction drive clutch levers are fully
disengaged.
3. Push Primer Bulb 2 or 3 times for cold
engine.
NOTICE: When temperature is below -15° F
(-26° C) additional priming may be needed.
4. If engine is cold, apply choke. See
Engine Manual for detailed instructions.
NOTICE: A warm engine requires less
choking than a cold engine.
5. Set throttle to proper starting position.
6. 921023, 035: Put the ignition key in the
ignition switch and turn it to the "Start"
position.
921024, 028, 029, 030, 032: Insert key
into ignition switch on engine and push
into RUN position. DO NOT twist key
after it is inserted.
7. 921024, 028, 029, 030, 032: Turn on the
engine shutoff switch (’RUN").
8. Grasp recoil starter handle and pull rope
out slowly until it pulls harder. Let rope
rewind slowly.
9. Pull rope with a rapid continuous full arm
stroke. Let rope rewind slowly.
IMPORTANT: DO NOT let recoil Starter
Handle snap against Starter.
10. Repeat steps 8 and 9 until engine starts.
(If engine does not start, refer to
TROUBLESHOOTING on page 36.)
11. Adjust choke as needed.
12. Set throttle to Part Throttle or Slow
position for adaptation to outside
temperature or travel. Set throttle to Fast
position for normal operation.
Electric Start (120V)
1. Connect extension cord to starter.
IMPORTANT: Prevent damage to unit. Know
voltage of your starter and only use matching
outlets.
2. Plug extension cord into 120V 3-wire,
grounded outlet.
IMPORTANT: Use an extension cord that is
capable of handling current requirements.
Cord should be rated for a minimum of 13
amps, grounded, UL listed, CSA certified and
labeled as suitable for outdoor use.
3. Turn discharge chute straight ahead.
4. Make sure that the attachment clutch
and traction drive clutch levers are fully
disengaged.
5. Push Primer Bulb 2 or 3 times for cold
engine.
NOTICE: When temperature is below -15° F
(-26° C) additional priming may be needed.
6. If engine is cold, apply choke. See
Engine Manual for detailed instructions.
NOTICE: A warm engine requires less
choking than a cold engine.
7. Set throttle to proper starting position.
8. 921023, 035: Put the ignition key in the
ignition switch and turn it to the "Start"
position.
921024, 028, 029, 030, 032: Insert key
into ignition switch on engine and push
into RUN position. DO NOT twist key
after it is inserted.
9. 921024, 028, 029, 030, 032: Turn on the
engine shutoff switch ("RUN").
10. Press starter button on engine until
engine starts.
IMPORTANT: DO NOT operate starter more
than 15 seconds per minute, as overheating
and damage can occur. (If engine does not
start, refer to TROUBLESHOOTING on
page 36.)
11. Adjust choke as needed.
12. Disconnect power cord from outlet, then
starter.
13. Set throttle to Part Throttle or Slow
position for adaptation to outside
temperature or travel. Set throttle to Fast
position for normal operation.
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in
personal injury and/or damage to
unit. DO NOT attempt to start your
unit at this time. Read entire
Owner/Operator Manual and the
Engine Manual first.
- 921 Series 1
- Sno-Thro 1
- INTRODUCTION 2
- TABLE OF CONTENTS 2
- UNAUTHORIZED REPLACEMENT 3
- DISCLAIMER 3
- DELIVERY 3
- 1. DANGER! 5
- 2. DANGER! 5
- 3. DANGER! 5
- EMISSION CONTROL SYSTEM 6
- ASSEMBLY 8
- PACKAGE CONTENTS 8
- (921023) 10
- Install Discharge Chute and 11
- 030, 032, 035) 11
- Remote Deflector Control 13
- CONTROLS AND FEATURES 15
- OPERATION 17
- FILLING FUEL TANK 20
- GASOLINE 20
- STARTING AND SHUT OFF 22
- Manual Start 22
- Electric Start (120V) 22
- Shut Off 23
- SNOW REMOVAL 23
- Tips for Operation 23
- TRAVELING 23
- TRANSPORT 23
- MAINTENANCE 24
- SCHEDULE 24
- GENERAL LUBRICATION 26
- SERVICE AND ADJUSTMENTS 27
- REMOTE DEFLECTOR 28
- CONTROL ADJUSTMENT 28
- DISCHARGE CHUTE (921028, 029) 28
- DISCHARGE CHUTE CONTROL 28
- (921023, 024, 030, 032, 035) 28
- SPEED SELECTOR ADJUSTMENT 29
- ATTACHMENT CLUTCH/BRAKE 29
- ADJUSTMENT 29
- Remove Attachment Cable Slack 29
- Clearance 30
- Check Attachment Brake 30
- TRACTION DRIVE CLUTCH 31
- TRACTION DRIVE BELT 32
- REPLACEMENT 32
- 921023, 024, 030, 032, 035 32
- 921028, 029 32
- FRICTION DISC REPLACEMENT 33
- TRACK TENSION ADJUSTMENT 34
- HEIGHT ADJUSTER CABLE 34
- ADJUSTMENT (921023) 34
- SERVICE PARTS 35
- ACCESSORIES 35
- TROUBLESHOOTING 36
- SPECIFICATIONS 37
- , Sno-Tek 39
- Chore Performing Equipment 39
- Limited Warranty 39
- Exceptions and Limitations 40
- Customer Responsibilities 40
- Sno-Chore_2012_Rev. A 41
- 655 West Ryan Street 42
- Brillion, WI 54110 42
- 920-756-4688 42
Related products and manuals for Garden tools Ariens Platinum 30
Garden tools Ariens 915501 Service Manual
(44 pages)
(44 pages)
Garden tools Ariens 986101 User Manual
(2 pages)
(2 pages)
Garden tools Ariens 920012 User Manual
(42 pages)
(42 pages)
Garden tools Ariens 920012 User Manual
(42 pages)
(42 pages)
Garden tools Ariens 920013 User Manual
(8 pages)
(8 pages)
Garden tools Ariens 920013 Operator's Manual
(41 pages)
(41 pages)
Garden tools Ariens 920012 User Manual
(32 pages)
(32 pages)
© 2020, manymanuals.com. All rights reserved. | 0.669 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals