Ariens 926502 - PB936 Specifications download pdf (Page 9)

GB - 9

Remote Differential

Squeeze and hold the remote differential lever to lock

differential so both wheels drive and provide better

traction. Release the remote differential lever to allow

easier steering.

Heated Handles

Turn the heated handles

switch to the

ON (1) position to activate. Turn the

switch to the OFF (2) position to

deactivate.

IMPORTANT: Do not activate heated

handles when using brush in warm weather.

BRUSH ANGLE ADJUSTMENT

To change the angle of the brush:

1. Release the attachment clutch and then the

traction clutch.

2. Loosen the T-nut on top of the adapter frame and

turn the brush as needed. See Figure 5.

3. Retighten the T-nut.

BRUSH HEIGHT ADJUSTMENT

IMPORTANT: If brush height is set too low, brush can

drive machine rearward when attachment clutch is

engaged. Engage brush slowly with brush set at proper

height.

Adjust caster wheels to the hole nearest 1/8-1/4 inch

(3-6 mm) above surface. For hard surfaces, adjust the

caster wheels so that brush just touches surface. The

brush works best with the brush properly leveled. To

adjust the brush height:

1. Move the brush to a dusty, flat surface. Leave the

engine running.

2. Start the brush at a slow speed. Run the brush in

a stationary position for 30 seconds.

3. Lift the brush head assembly off the ground and

reverse the unit to move it away from the swept

area.

4. Stop engine and allow all moving parts to stop.

5. Check the width of the swept area. The brush

pattern should be 2-3 inches (5.08-7.6 cm) wide,

running the length of the brush. (See Figure 6).

6. To adjust, remove the caster wheel support pins

(one each side). Slide caster wheel supports up

or down as required. Align the holes in the outer

sleeve with the holes in the wheel supports.

7. Reinstall the adjustment pins at the new position.

8. Repeat steps 1- 7 until proper adjustment is

attained.

FUEL SHUT-OFF VALVE

IMPORTANT: The fuel shut-off valve MUST be in the

closed position prior to transporting the unit.

The fuel shut-off valve has two positions:

• Closed Position: Use this position to service,

transport, or store the unit.

• Open Position: Use this position to run the unit.

OS1950

Figure 5

1.T-Nut

2.Brush Adapter Housing

3.Attachment Drive Pulley

OSs0083

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

Figure 6

1. Swept Area

2. Caster Wheel

3.Height

Adjusting Pin

2-3 in

(5.08-7.6 cm)

OS0061

Figure 7

OPENCLOSED

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Comments to this Manuals

No comments

Ariens 926502 - PB936 Specifications Page 9

Comments to this Manuals

Related products and manuals for Garden tools Ariens 926502 - PB936