Ariens 926502 - PB936 Specifications download pdf (Page 12)

GB - 12

Ariens Dealers will provide any service or adjustments

which may be required to keep your unit operating at

peak efficiency. Should engine service be required,

contact an Ariens dealer or an authorized engine

manufacturer's service center.

SERVICE POSITION

IMPORTANT: DO NOT tip unit up onto brush. Remove

the brush if maintenance requires tipping the unit

forward. Ensure unit is secure and will not tip over.

Strap or clamp unit onto bench if required.

To access components in the unit frame:

1. Shut off engine and allow unit to cool completely.

Place unit on a flat level surface.

2. Remove belt cover (Figure 8).

3. Remove the rear cap screws from the bottom

cover. Loosen the side cap screws and remove

the bottom cover before separating unit.

4. Loosen cap screws and carefully rotate belt

fingers away from belt and sheave (Figure 8).

IMPORTANT: Use care when rotating the belt fingers.

DO NOT bend belt fingers out of shape.

5. Remove attachment drive belt from engine

sheave (it may be necessary to turn engine

sheave using recoil starter handle).

6. Support unit frame and brush attachment.

7. Remove cap screws securing attachment to unit

frame (one on each side). Tip attachment and

frame apart on pivot rod.

8. Remove attachment belt from attachment pulley.

9. Separate frame from brush.

MAINTENANCE SCHEDULE

The chart below shows the recommended

maintenance schedule that should be performed on a

regular basis. More frequent service may be required

due to working conditions (heavy loads, high ambient

temperatures, dusty conditions, or airborne debris).

* After first five hours of operation.

** After first two hours of operation.

*** Grease universal joint after first 16 hours of

operation and every 8 hours thereafter.

MAINTENANCE

WARNING: AVOID INJURY. Read and

understand the entire Safety section

before proceeding.

CAUTION: Always support unit frame and

brush attachment when loosening the cap

screws holding them together.

MAINTENANCE SCHEDULE

Service Performed Each Use Every 5

hrs.

Every 25

hrs.

Yearly

Check Dual Handle

Interlock

•

Check Fasteners •

Check Clutch

Operation

•

Check Clutch Spring

Adjustments

•

Clean Engine •

Check Engine Oil •

Change Engine Oil

•

Check Tire Pressure •

General Lubrication

***

••

Figure 8

1.Belt Cover

2.Rear Cap Screws

3.Bottom Cover

4. Side Cap Screws

5. Pivot Rod

6. Brush Frame Adapter

7. Brush Mounting Cap

Screw

OSS0271

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Comments to this Manuals

No comments

Ariens 926502 - PB936 Specifications Page 12

Comments to this Manuals

Related products and manuals for Garden tools Ariens 926502 - PB936