Ariens 926502 - PB936 Specifications download pdf (Page 11)

GB - 11

6. Repeat until engine starts. (If engine does not

start, refer to Troubleshooting.)

7. Adjust choke as needed.

8. Set throttle to Part Throttle or Slow position for

adaptation to outside temperature or travel. Set

throttle to Fast position for normal operation.

Shut Off

1. Release attachment clutch lever and wait for all

moving parts to come to a complete stop.

2. Release traction drive clutch lever and allow unit

to come to a complete stop.

3. Run unit a few minutes after use to prevent

freeze-up.

4. Move throttle to Part Throttle or Slow position.

5. Turn off engine shut-off switch ("O").

USING THE BRUSH

After proper Pre-Start and Starting:

1. Select speed control position and direction.

IMPORTANT: DO NOT overload unit capacity by

sweeping at too fast a rate.

2. Engage the traction drive clutch first.

3. Engage the attachment clutch next.

Tips for Sweeping

To clear an area, run unit in an overlapping series of

paths. For large areas, start in the middle and sweep

debris to each side, so it is not cleared more than once.

ALWAYS direct discharge away from area to be

cleared and with direction of the wind.

Snow is best removed as soon as possible after snow

fall.

Tips for Dethatching

Dethatch in the spring to clear winter undergrowth.

Adjust brush height so it just touches the grass.

Set the brush angle full left or full right so thatch gets

cleared only once.

Dethatch dry grass.

Use a slow speed to clear thatch without damaging the

lawn.

TRAVELING

To travel from one work area to another:

1. Set throttle to SLOW position or slightly higher.

2. Press down the handlebars enough to raise the

front of the unit slightly off the surface.

3. Engage traction clutch without engaging the

attachment drive clutch.

TRANSPORT

ALWAYS shut off engine and close fuel shut-off when

transporting unit on a truck or trailer.

Use extra care when loading or unloading unit onto

trailer or truck.

Secure unit chassis to transport vehicle. NEVER

secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

SHORT TERM

IMPORTANT: NEVER spray unit with high-pressure

water or store unit outdoors.

Run unit a few minutes after each use to free unit of

any debris.

Inspect unit for visible signs of wear, breakage or

damage.

Keep all nuts, bolts and screws properly tightened and

know unit is in safe working condition.

Close fuel shut-off valve.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low pressure

water and lubricate (see Maintenance). Touch up all

scratched painted surfaces.

Remove weight from wheels by putting blocks under

frame or axle.

When storing unit for extended periods of time, remove

all fuel from tank and carburetor (run dry). Refer to

Engine Manual.

STORAGE

WARNING: AVOID INJURY. Read and

understand the entire Safety section

before proceeding.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Comments to this Manuals

No comments

Ariens 926502 - PB936 Specifications Page 11

Comments to this Manuals

Related products and manuals for Garden tools Ariens 926502 - PB936