Ariens 926502 - PB936 Specifications download pdf (Page 13)

GB - 13

CHECK DUAL HANDLE INTERLOCK

Without the engine running, press down (engage) both

clutch levers. Release attachment clutch lever.

Attachment clutch should remain engaged until traction

clutch lever is released, then both clutches must

disengage.

CHECK FASTENERS

Make sure all hardware is tightened properly.

CHECK CLUTCH OPERATION

Brush must stop quickly when attachment clutch lever

is released.

Wheels must stop quickly when traction drive clutch

lever is released.

If clutches do not engage or disengage properly, adjust

or repair before operation (see Service and

Adjustments).

CHECK CLUTCH SPRING ADJUSTMENT

Make sure the attachment clutch and traction drive

clutch are adjusted to the range specified in

Attachment Clutch/Brake Adjustment on page 14 and

in Traction Drive Clutch Adjustment on page 15.

CLEAN ENGINE

Refer to Engine Manual for detailed instructions.

CHECK ENGINE OIL

The engine crankcase oil should be checked every 5

hours of operation. Oil level MUST be maintained in

safe operating range on dipstick at all times or engine

damage will result (see Engine Manual).

Park unit on a level surface. Refer to Engine Manual for

detailed instructions.

CHANGE ENGINE OIL

Change oil after first 2 hours of operation, thereafter

change oil every 25 hours (more often if required).

Refer to Engine Manual for detailed instructions.

Run engine just prior to changing oil. Warm oil will flow

more freely and carry away more contamination.

CHECK TIRE PRESSURE

Keep tires at pressure listed on the tire sidewall.

GENERAL LUBRICATION

Brush

1. Follow the instructions for removing the brush

attachment from unit frame. See Service Position.

IMPORTANT: Wipe each lube fitting clean before and

after lubrication. DO NOT allow grease or oil to get on

the friction disc, drive disc or belts.

2. Apply grease to lube fitting on universal joint after

the first 16 hours of use and every 8 hours

thereafter.

NOTE: Apply Stens Mix Hi-Temp Grease or equivalent.

3. Apply a few drops of oil to the chain, idler pivot

and other pivot points at the beginning of the

season or every 25 operating hours.

4. Attachment gear box is lubricated at the factory

and should not require additional lubrication.

Drive

IMPORTANT: Wipe each lube fitting clean before and

after lubrication. DO NOT allow grease or oil to get on

the friction disc, drive disc or belts.

NOTE: Apply Stens Mix Hi-Temp Grease or equivalent

to the lube fittings (Figure 9).

Figure 9

OS0743

Grease Oil

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Ariens 926502 - PB936 Specifications Page 13

Comments to this Manuals

Related products and manuals for Garden tools Ariens 926502 - PB936