Ariens 926502 - PB936 Specifications download pdf (Page 10)

GB - 10

FILLING FUEL TANK

To add fuel to the tank:

1. ALWAYS place unit in an open, well- ventilated

area.

2. Stop engine and allow to cool.

3. Clean fuel cap and surrounding area to prevent

dirt from entering the fuel tank.

4. Remove cap.

IMPORTANT: See engine manual for correct type and

grade of fuel to use.

5. Fill fuel tank to within 1/2 inch (1.27 cm) below

bottom of filler neck. Tank capacity is 4.0 qts

(3.8 liters).

6. Replace fuel cap and tighten.

7. ALWAYS clean up any spilled fuel.

PRE-START

1. Check Engine Air Cleaner Position (Climate

Guard)

IMPORTANT: See Engine Manual for correct

orientation of air cleaner cover prior to starting engine.

2. Check Function of Clutches

Brush must stop quickly when attachment clutch lever

is released.

Wheels must stop quickly when traction drive clutch

lever is released.

If clutches do not engage or disengage properly, adjust

or repair before operation (see Service and

Adjustments).

3. Check Dual Handle Interlock

Without the engine running, press down (engage) both

clutch levers. Release attachment clutch lever.

Attachment clutch should remain engaged until traction

clutch lever is released, then both clutches must

disengage.

If clutches do not engage or disengage properly, adjust

or repair before operation (see Service and

Adjustments).

4. Check Remote Differential

Test the remote differential lock before starting.

Squeeze and hold the remote differential lever to lock

differential so both wheels drive and provide better

traction. Release the remote differential lever to allow

easier steering.

5. Adjust Brush

Adjust brush height and angle before operation. See

Brush Adjustments.

6. Check Engine Fuel and Crankcase Oil

Check and add fuel if required. Check that the engine

crankcase oil is full using dipstick. Refer to Engine

Manual for detailed instructions.

TO STOP IN AN EMERGENCY

Immediately release both control levers to stop unit in

an emergency. Stop engine and wait for all rotating

parts to stop before leaving operator’s position.

STARTING AND SHUT OFF

IMPORTANT: At start-up, allow unit and engine to

adjust to the outside temperature before operating.

Before shut-off, run unit a few minutes to prevent

freeze-up.

NOTE: Try out each control without the engine running

to see how they work and what they do.

Manual Start

1. Make sure that the traction clutch and attachment

clutch levers are fully disengaged.

2. Turn on engine shut-off switch ("I").

3. If engine is cold, apply choke. A warm engine

requires less choking than a cold engine. See

Engine Manual for detailed instructions.

4. Set throttle to proper starting position.

5. Pull rope with a rapid continuous full arm stroke.

Let rope rewind slowly.

IMPORTANT: DO NOT let Starter Handle snap against

Starter.

WARNING: FLAMMABLE FUEL and its

EXPLOSIVE VAPORS can result in death

or serious injury. Handle fuel with extreme

care. ALWAYS use an approved fuel

container. NO Smoking! NO Lighted

Materials! No Open Flames! Allow engine

to cool before any service.

This side out for use ABOVE 32°F

(0°C).

This side out for use BELOW 32°F

(0°C).

WARNING: AVOID INJURY. Read and

understand the entire Safety section

before proceeding.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments

Ariens 926502 - PB936 Specifications Page 10

Comments to this Manuals

Related products and manuals for Garden tools Ariens 926502 - PB936