Ariens SNO-THRO 938019 - 522 Specifications download pdf (Page 18)

GB - 18

TO ADJUST IDLER POSITION

The idler must be as close as possible to the

drive belt when the auger clutch is

disengaged, but not so close that it causes

auger rotation.

To adjust the idler position:

IMPORTANT: If adjustment cannot be

achieved, the drive belt must be replaced.

1. Shut off engine, allow to cool, and remove

cowl.

2. Ensure control cable has some slight,

noticeable slack when auger clutch is

disengaged (bail in lowered position).

3. Ensure belt ﬁnger is properly adjusted.

See To Adjust Belt Finger.

4. Loosen idler hardware, reposition idler

along slot in idler arm, and tighten

hardware (Figure 13).

5. Check for proper extension of control

cable spring. See To Adjust Auger Control

Cable.

6. Start engine and ensure auger does not

rotate when auger clutch is disengaged.

7. Shut off engine.

8. Repeat the above steps until proper

adjustment is achieved.

9. Replace cowl.

SHORT TERM

IMPORTANT: NEVER spray unit with high

pressure water or store unit outdoors.

Run with attachment clutch engaged a few

minutes after each use to free unit of any

loose or melting snow.

Inspect unit for visible signs of wear, breakage

or damage.

Keep all nuts, bolts and screws properly

tightened and know unit is in safe working

condition.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low

pressure water and lubricate (see

Maintenance). Touch up all scratched painted

surfaces.

Remove weight from wheels by putting blocks

under frame or axle.

When storing unit for extended periods of

time, remove all fuel from tank and carburetor

(run dry). Refer to Engine Manual.

WARNING: ROTATING PARTS

can cut off body parts. Keep

hands and feet away. Loose

clothing, long hair or scarves

can get caught in rotating parts

and cause death or serious

injury.

1. Idler Arm/Brake

2. Idler

3. Slot

4. Auger Clutch

Control Cable

5. Belt Finger

OS0054

1

2

3

4

5

1/32 -1/16 in

(1-1.6 mm)

Figure 13

STORAGE

WARNING: AVOID INJURY>

Read and understand Storage

Safety Rules in Safety section

before proceeding.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments