Ariens SNO-THRO 938019 - 522 Specifications download pdf (Page 11)

GB - 11

Discharge Chute Crank Assembly

(938017, 018)

1. Remove nut from bolt that holds recoil

starter handle bracket in place

(Figure 7).

2. Pull the chute crank assembly up so hole

in chute crank bracket ﬁts behind/under

lower handle bar and over bolt end.

NOTE:

DO NOT pull chute crank bracket past

the lower handle bar or the 48T gear and

spacer will fall off into unit.

3. With crank knob straight up and

discharge chute straight forward, check

that 48T gear meshes with 12T pinion.

Align space and tooth identiﬁcation

marks.

4. Insert cotter pin (taped to chute crank

assembly) through 48T gear and chute

crank shaft. Slight movement of the crank

shaft or discharge chute may be needed

to align holes.

5. Rotate chute crank to access cotter pin.

Secure pin by bending ends over.

6. Secure chute crank and starter handle to

lower handle bar by reinstalling nut from

step 1.

CHECKLIST

Please complete the following checklist before

proceeding:

❑

All assembly instructions have been

completed.

❑

No remaining loose parts in carton.

❑

Handlebar is adjusted comfortably and

tightened securely.

While learning how to use your unit, pay

extra attention to the following important

items:

❑

Fill fuel tank with proper gasoline/oil mix.

❑

Become familiar with all controls – their

location and function.

❑

Be certain that all hardware is properly

tightened.

CONTROLS AND FEATURES

Refer to Figure 1 for controls and features

locations.

Ignition Switch

The ignition switch is operated with a

removable key that has two positions.

"STOP" Position: Ignition

system is shut down.

"RUN" Position: All controls

are operable.

To start the engine, the key

must be in the "RUN" position.

To stop the engine, turn the

key to the "STOP" position.

Auger

When handlebar is lifted so auger contacts the

ground, auger propels unit forward while

collecting snow. Forward speed will vary

according to depth and moisture content.

Auger Clutch Bail

Squeeze the auger

clutch bail against the

handlebar to engage

auger.

Release bail to

disengage and brake

auger.

IMPORTANT:

Check auger to be sure it is not

frozen. If belt squeals when clutch bail is

engaged, auger is frozen. Immediately release

the clutch bail and move the unit to a heated

area to thaw.

OPERATION

WARNING:

AVOID INJURY. Read

and understand

Operational

Safety Rules

and

Fuel Safety

Rules

before proceeding.

STOP

RUN

OS1680

WARNING:

IMPROPER

ADJUSTMENT could result in

death or serious injury. AUGER

BRAKE MUST DISENGAGE

when clutch is engaged. BRAKE

MUST STOP AUGER WITHIN 5

SECONDS of releasing auger

clutch bail.

Engaged

Disengaged

OS1562

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Comments to this Manuals

No comments