Ariens SNO-THRO 938019 - 522 Specifications download pdf (Page 16)

GB - 16

SERVICE POSITION

Place unit on a ﬂat level surface.

HANDLEBARS

Adjust upper handlebar by selecting alternate

holes for "J" Bolts.

Tighten handlebar knobs to secure upper

handlebar.

The upper handlebar can be folded for

storage.

TO ADJUST DISCHARGE CHUTE

If discharge chute rotates while throwing

snow, torque the four screws holding it to the

housing to 11-12 lbf-in (1.23-1.35 N•m). See

Figure 9.

IMPORTANT: Overtightening screws will strip

the screw holes.

1. Remove nut and bolt from rear of

discharge chute.

2. Tip discharge chute forward.

3. Tighten two rear screws.

4. Tighten two front screws.

5. Reposition discharge chute and fasten

with nut and bolt.

TO ADJUST DISCHARGE CHUTE

DEFLECTOR

If discharge chute deﬂector does not stay in

set position during operation, adjust chute by

tightening fasteners evenly until deﬂector

stays in position (Figure 10).

NOTE: Use a T30 Torx Drive or a 3/16” (5 mm)

wide Straight Screwdriver to tighten.

TO REPLACE THE DRIVE BELT

1. Remove fuel cap.

2. Remove cowl and replace fuel cap.

3. Disconnect extension spring on idler arm/

brake (Figure 11).

4. Remove cap screw and washer from end

of auger shaft and pull off auger drive

pulley.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read

and understand Maintenance and

Service Safety Rules in Safety

section before attempting service

or adjustments.

CAUTION: Adjust auger control

cable after changing handlebar

height.

Figure 9

1. Rear Screw

2. Rear Nut and Bolt

3. Discharge Chute

4. Front Screw

1

2

3

4

Fasteners

OS0181

Figure 10

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments