Ariens SNO-THRO 938019 - 522 Specifications download pdf (Page 12)

GB - 12

IMPORTANT:

Check clutch/brake function

before each use. If auger clutch bail moves

freely with no resistance before contacting

handlebar, adjust or repair unit before

operating.

Primer Bulb

Push in the primer bulb to add

fuel for easier engine start. See

Starting and Shut Off

.

Choke Control Knob

When pulled out (away from

auger housing) the choke

control knob chokes off air to

the engine for easier start.

When pushed in, control knob

allows for normal operation.

IMPORTANT:

When engine has started, open

choke slowly by gradually pushing choke

control in.

Recoil Starter Handle

When pulled, handle will crank engine.

IMPORTANT:

DO NOT let handle snap back

against unit.

Discharge Chute

Discharge Chute rotates 220°. Rotate chute

with discharge chute handle.

Chute Crank Handle (938017, 018)

Rotate the Chute with Discharge Chute Crank

Handle (Figure 8).

IMPORTANT:

DO NOT force frozen Chute

controls. Start engine and run for 3-5 minutes

to thaw. If still frozen, take to warm place until

controls are free.

Discharge Chute Deﬂector

The discharge chute deﬂector controls how

high snow is thrown.

Use handle at rear of deﬂector to position

deﬂector at desired height.

Push down handle to increase height of

discharge.

Pull up on handle to decrease height of

discharge.

IMPORTANT:

If chute deﬂector does not stay

in set position, adjust as directed in

To Adjust

Discharge Chute Deﬂector

, or repair before

operation.

Handlebars

Adjust upper handlebar by selecting alternate

holes for "J" Bolts.

Tighten handlebar knobs to secure upper

handlebar.

The upper handlebar can be folded for

storage.

Scraper Blade

The scraper blade allows the back of the

housing to keep better contact with the surface

being cleared. It also prevents damage to the

housing from normal wear.

IMPORTANT: DO NOT allow scraper blade to

wear down too far or auger housing will

become damaged.

Fuel Level Indicator

The fuel level indicator is an extension of the

fuel tank that allows you to see the level of fuel

in the tank without removing the fuel cap.

FILLING FUEL TANK

Check fuel level by looking at fuel level

indicator on rear of unit. Add fuel as required.

To add fuel to fuel tank:

IMPORTANT: Two cycle engines require that

oil be mixed with fuel. Failure to mix oil with

fuel will result in seizure and severe damage

to engine. DO NOT use gasohol or gasoline

containing alcohol because alcohol will cause

internal parts to deteriorate. See Engine

Manual for correct type and grade of fuel.

OS1620

OS1570

Chute Crank Handle

Figure 8

OS2060

Discharge

Chute Handle

CAUTION: Adjust auger control

cable after changing handlebar

height.

WARNING: AVOID INJURY. Read

and understand Fuel Safety Rules

in Safety section before

proceeding.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Comments to this Manuals

No comments