Ariens Hydro Pro 28 Specifications download pdf (Page 8)

EN - 8

PACKAGE CONTENTS

ASSEMBLY

Tools Required:

•Pliers

• Open-End Wrenches: 3/8, 7/16, 1/2,

9/16, 3/4" and/or Adjustable Wrench

• Tire Gauge

• Socket, 3/4"

• Torque Wrench (Optional)

Unfold Handlebar

(Figure 4)

1. Remove the lower and loosen the upper

hardware on the handlebar assembly.

2. Loosen the hardware on the shift rod.

3. Put the speed selector lever in the

fastest reverse position.

4. Rotate the handlebars into operating

position.

IMPORTANT: Be careful not to damage cable

spring hooks when rotating handlebars

upward.

5. Install and tighten all hardware on the

handlebar assembly and shift rod.

NOTE: The handlebar has two height

positions. Adjust the handlebar height to

provide better operator comfort. See

Handlebar Height on page 25.

6. Check tension on auger and traction

clutch cables.

IMPORTANT: Cables should not be slack or

under tension. Adjust as necessary.

Install Discharge Chute, Chute

Control and Chute Rod

(Figures 5, 6 and 7)

1. Grease underside of discharge chute

ring (if not already greased).

2. Remove mounting hardware from auger

housing.

3. Install discharge chute over opening in

the auger housing. Finger tighten the

mounting hardware removed in step 2.

ASSEMBLY

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: Dropping or tipping

over boxed unit could result in

personal injury or damage to unit.

Figure 3

1. Sno-Thro Unit

2. Discharge Chute

3. Chute Rod

4. Literature Pack

1

2

4

3

OS7020

1. Handlebar

Hardware

2. Shift Rod

Hardware

3. Shift Rod

4. Speed

Selector

Lever

Figure 4

OS7030

1

3

2

4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Comments to this Manuals

No comments