Ariens Hydro Pro 28 Specifications download pdf (Page 20)

EN - 20

SNOW REMOVAL

IMPORTANT: Allow unit and engine to adjust

to the outdoor temperature before clearing

snow.

NOTE: Attachment clutch should be engaged

before traction drive clutch when throwing

snow.

1. Select Speed Control position and

direction.

2. Engage Attachment Clutch – Right Hand

Lever.

3. Engage Traction Drive Clutch – Left

Hand Lever.

IMPORTANT: DO NOT overload unit capacity

by attempting to clear snow at too fast a rate.

Use slow speed to clear deep or hard packed

snow.

Tips for Operation

Snow is best removed as soon as possible

after snow fall.

To clear an area, run unit in an overlapping

series of paths. For large areas, start in the

middle and throw snow to each side, so snow

is not cleared more than once.

ALWAYS direct snow away from area to be

cleared and with direction of the wind.

TRAVELING

To travel from one work area to another:

1. Set Throttle to Slow or Part-Throttle

position.

2. 926053, 054, 055: Press down on

handlebars enough to raise front of unit

slightly off surface.

926056: Place the unit in the transport

position (see Track Angle on page 17).

3. Engage traction drive clutch without

engaging attachment drive clutch.

TRANSPORT

ALWAYS shut off engine, remove key, and

close fuel shut-off valve when transporting

unit on a truck or trailer.

Use extra care when loading or unloading

unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

DO NOT transport machine while engine is

running.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Comments to this Manuals

No comments