Ariens Hydro Pro 28 Specifications download pdf (Page 17)

EN - 17

Track Angle

(926056)

(Figure 15)

The track angle can be adjusted to position

the auger housing for level clearing, deep

cutting or transport.

Squeeze the handlebar trigger and press

down on the handlebars to move the auger

housing into an up position. Release the

trigger to hold the position.

Squeeze the handlebar trigger and lift up on

the handlbars to move the auger housing into

a down position. Release the trigger to hold

the position.

FILLING FUEL TANK

GASOLINE

IMPORTANT: ALWAYS use gasoline that

meets the following guidelines:

• Clean, fresh gasoline.

• A minimum of 87 octane/87 AKI (91

RON). High altitude use may require a

different octane. Consult your engine

manual.

• Gasoline with up to 10% ethanol

(gasohol) or up to 10% MTBE (methyl

tertiary butyl ether) is acceptable.

• Use of any gasoline other than those

approved above will void the engine

warranty. If the pumps are not marked

for the content of alcohol or ethers,

check ethanol and MTBE levels with

the fuel supplier.

• Do not modify the fuel system to use

different fuels.

• Never mix oil and gasoline.

Figure 14

OS7110

Stored Position

Operating Position

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Figure 15

Deep Cutting

OS7111

Transport

Normal

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments