Ariens Hydro Pro 28 Specifications download pdf (Page 15)

EN - 15

Choke Control Knob

1.Choke Closed

position: chokes off

air to engine for

easier start.

2.Choke Open

position: allows for

normal operation.

IMPORTANT:

Gradually open choke

after engine starts.

Throttle

The throttle controls the engine speed. To

increase or decrease the engine speed,

adjust to:

1. Fast

2. Part-Throttle

3. Slow

Electric Starter

The electric starter will start a properly

choked and cranked engine when the starter

button is pushed. Refer to Starting and Shut

Off on page 19.

Recoil Starter Handle

When pulled, recoil starter handle will turn

engine over.

IMPORTANT: DO NOT let recoil starter

handle snap back against starter.

Snow Clean-Out Tool

(Figure 11)

To clear the discharge chute:

1. Shut off the engine.

2. Wait 10 seconds and make sure impeller

blades have stopped rotating.

3. Remove the snow clean-out tool from

the auger housing and use it to remove

the clog from the discharge chute.

4. Replace the snow clean-out tool on the

auger housing.

Remote Deflector Control

Place deflector into position before operation.

DO NOT throw snow any higher than

necessary.

Place deflector remote in a forward notch to

throw snow lower. Place deflector remote in a

rearward notch to throw snow higher.

Discharge Chute

Discharge chute rotates 200°.

ALWAYS position discharge chute in safe

direction and angle, away from operator and

bystanders, before starting engine.

Quick-Turn Chute Control

(Figure 12)

IMPORTANT: If chute does not stay in set

position, adjust as directed in Discharge

Chute Control on page 26, or repair before

operation.

Rotate discharge chute with Quick-Turn

Chute Control (Figure 12).

WARNING: Hand contact with the

rotating impeller is the most

common cause of injury associated

with snow throwers. Never use your

hand to clean out the discharge

chute.

',3/)

692

2

1

OS7275

3

2

1

Figure 11

OS7101

Snow Clean-Out Tool

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Comments to this Manuals

No comments