Ariens Hydro Pro 28 Specifications download pdf (Page 19)

EN - 19

5. Check Engine Fuel & Crankcase

Oil

Check and add fuel if required. Check that

the engine crankcase oil is full using dipstick.

Refer to Engine Manual for detailed

instructions.

TO STOP IN AN EMERGENCY

Immediately release both control levers to

stop unit in an emergency. Stop engine,

remove key and wait for all rotating parts to

stop before leaving operator’s position.

STARTING AND SHUT OFF

IMPORTANT: Allow unit and engine to adjust

to the outdoor temperature before clearing

snow. Before shut-off, run the attachment a

few minutes to prevent impeller freeze-up.

NOTE: Try out each control without the

engine running to see how it works and what

it does.

Manual Start

1. Turn discharge chute straight ahead.

2. Make sure that the attachment clutch

and traction drive clutch levers are fully

disengaged.

3. Push Primer Bulb 2 or 3 times for cold

engine.

NOTE: When temperature is below -15° F

(-26° C) additional priming may be needed.

4. If engine is cold, apply choke. See

Engine Manual for detailed instructions.

NOTE: A warm engine requires less choking

than a cold engine.

5. Set throttle to proper starting position.

6. Insert key into ignition switch and turn to

"Run" position.

7. Grasp starter handle and pull rope out

slowly until it pulls harder. Let rope

rewind slowly.

8. Pull rope with a rapid continuous full arm

stroke. Let rope rewind slowly.

IMPORTANT: DO NOT let Starter Handle

snap against Starter.

9. Repeat steps 7 and 8 until engine starts.

(If engine does not start, refer to

TROUBLESHOOTING on page 32.)

10. Adjust choke as needed.

11. Set throttle to Part Throttle or Slow

position for adaptation to outside

temperature or travel. Set throttle to Fast

position for normal operation.

Electric Start (120V)

1. Connect extension cord to starter.

IMPORTANT: Prevent damage to unit. Know

voltage of your starter and only use matching

outlets.

2. Plug extension cord into 120V 3-wire,

grounded outlet.

IMPORTANT: Use an extension cord that is

capable of handling current requirements.

Cord should be rated for a minimum of

13 amps, grounded, UL listed, CSA certified

and labeled as suitable for outdoor use.

3. Turn discharge chute straight ahead.

4. Make sure that the attachment clutch

and traction drive clutch levers are fully

disengaged.

5. Push Primer Bulb 2 or 3 times for cold

engine.

NOTE: When temperature is below -15° F

(-26° C) additional priming may be needed.

6. If engine is cold, apply choke. See

Engine Manual for detailed instructions.

NOTE: A warm engine requires less choking

than a cold engine.

7. Set throttle to proper starting position.

8. Insert key into ignition switch and turn to

"Run" position.

9. Press starter button on engine until

engine starts.

IMPORTANT: DO NOT operate starter more

than 15 seconds per minute, as overheating

and damage can occur. (If engine does not

start, refer to TROUBLESHOOTING on

page 32.)

10. Adjust choke as needed.

11. Disconnect power cord from outlet, then

starter.

12. Set throttle to Part Throttle or Slow

position for adaptation to outside

temperature or travel. Set throttle to Fast

position for normal operation.

Shut Off

1. Release Traction Drive Clutch Lever and

allow unit to come to a complete stop.

2. Run Impeller a few minutes after use to

prevent freeze-up of Impeller.

3. Release Attachment Clutch Lever and

wait for all moving parts to come to a

complete stop.

4. Move Throttle to the “Slow” position.

5. Turn off engine shut-off switch ("OFF").

6. Remove key.

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: FAILURE TO FOLLOW

INSTRUCTIONS could result in

personal injury and/or damage to

unit. DO NOT attempt to start your

unit at this time. Read entire

Owner/Operator Manual and the

Engine Manual first.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Comments to this Manuals

No comments

Ariens Hydro Pro 28 Specifications Page 19

Comments to this Manuals

Related products and manuals for Snow throwers Ariens Hydro Pro 28