Ariens 920402 - Sno-Tek 24E Operator's Manual download pdf (Page 21)

EN – 20

4. Align holes in auger with holes in auger shaft and

reinstall shear bolt. Torque bolt to 5.8 – 12.2 lbf-ft

(7.9 – 16.5 N•m). If torque wrench is unavailable,

tighten until bolts no longer spin freely. DO NOT

overtighten.

5. Reinstall bushing onto auger shaft end.

See Figure 30.

6. Reinstall auger assembly into auger housing so

impeller shaft is seated in ball bearing at rear of

housing.

7. Align holes in bushings on auger ends with holes in

housing and secure with six tapping screws. Tighten

hardware.

See Figure 31.

8. Tighten three hex nuts securing bearing plate to

housing.

9. Align hub on attachment drive pulley with impeller

shaft.

10. Reinstall attachment drive pulley assembly onto

impeller shaft and secure with locking washer and hex

bolt. Torque to 5.8 – 12.2 lbf-ft (7.9 – 16.5 N•m).

11. Reinstall attachment drive belt. See Install Attachment

Drive Belt on page 12.

12. Reconnect spark plug wire.

Figure 30

1. Impeller Shaft

2. Ball Bearing

Figure 31

1. Impeller Shaft

2. Attachment Drive Pulley

3. Locking Washer

4. Hex Bolt

5. Hex Nut

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Ariens 920402 - Sno-Tek 24E Operator's Manual Page 21