Ariens 920402 - Sno-Tek 24E Operator's Manual download pdf (Page 28)

EN – 27

Install Chute Rotation Gear

1. Position discharge chute facing forward.

See Figure 43.

2. Position chute rotation gear on chute mount so gear

teeth at halfway point align with pinion gear.

3. Align hole in chute gear with holes in chute mount, flat

steel washer, friction washer, and pedestal plate.

NOTICE: A flat steel washer and friction washer are

positioned between chute mount and pedestal plate and

are not to be removed.

4. Insert round head square neck bolt through hole in

chute gear.

5. Reinstall friction washer, friction plate, compression

spring, and hex nut onto bolt. Tighten hex nut.

IMPORTANT: Make sure notch in friction plate fits around

tab in chute mount.

6. Reinstall gear cover and secure with two tapping

screws.

7. Adjust discharge chute rotation. Refer to Operator’s

Manual for adjustment procedure.

8. Reconnect spark plug wire.

SCRAPER BLADE REPLACEMENT

Remove Scraper Blade

NOTICE: Save all hardware for reinstallation.

1. Stop engine, remove key and wait for all moving parts

to stop and for hot parts to cool.

2. Disconnect spark plug wire from engine.

3. Place unit in service position. See Service Position on

page 8.

See Figure 44.

4. Remove hardware securing scraper blade to auger

housing and remove scraper blade.

Install Scraper Blade

1. Position new scraper blade inside auger housing and

align holes with holes in housing.

2. Insert five flat head square neck bolts through holes

from inside auger housing and secure with hex nuts.

3. Return unit to operating position.

4. Adjust scraper blade and skid shoes. Refer to

Operator’s Manual for adjustment procedures.

5. Fill fuel tank and reconnect spark plug wire.

Figure 43

1. Chute Mount

2. Pedestal Plate

3. Chute Rotation Gear

4. Pinion Gear

WARNING: AVOID INJURY. Before placing unit

in service position, close fuel valve and drain fuel

from tank and fuel system. See Draining Fuel

System on page 8. Make sure unit is secure and

will not tip.

Figure 44

1. Hex Nut

2. Scraper Blade

3. Flat Head Square Neck Bolt

1 2 ... 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Ariens 920402 - Sno-Tek 24E Operator's Manual Page 28

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 920402 - Sno-Tek 24E