Ariens 920402 - Sno-Tek 24E Operator's Manual download pdf (Page 17)

EN – 16

8. Remove bottom cover. See Bottom Cover Removal on

page 9.

See Figure 19.

9. Check attachment brake:

• Brake must contact attachment belt when

attachment clutch is disengaged.

• Brake must be more than 1.6 mm away from

attachment belt when attachment clutch is engaged.

10. Reinstall bottom cover and secure with six hex bolts.

11. Reinstall wheels and secure with axle lock pins.

12. Return unit to operating position and fill fuel tank.

13. Adjust attachment clutch / brake. Refer to Operator’s

Manual for adjustment procedure.

14. Reconnect spark plug wire.

FRICTION DISC REPLACEMENT

Remove Friction Disc

NOTICE: Save all hardware for reinstallation.

1. Stop engine, remove key and wait for all moving parts

to stop and for hot parts to cool.

2. Disconnect spark plug wire from engine.

3. Place unit in service position. See Service Position on

page 8.

4. Remove bottom cover. See Bottom Cover Removal on

page 9.

See Figure 20.

5. Remove hairpin securing adjustment pivot pin to

speed selector arm and remove adjustment pivot pin

from speed selector arm.

WARNING: AVOID INJURY. Auger / impeller

must stop within 5 seconds when attachment

clutch lever is released.

Figure 19

1. Attachment Drive Belt

2. Brake Pad

WARNING: AVOID INJURY. Before placing unit

in service position, close fuel valve and drain fuel

from tank and fuel system. See Draining Fuel

System on page 8. Make sure unit is secure and

will not tip.

Figure 20

1. Speed Selector Arm

2. Hairpin

3. Adjustment Pivot Pin

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments

Ariens 920402 - Sno-Tek 24E Operator's Manual Page 17

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 920402 - Sno-Tek 24E