Ariens 920013 Specifications Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
EN - 35
13. Insert new friction disc assembly into
frame. Install washers onto carrier
bearing and slide into speed selector
arm.
14. Slide hex shaft through new friction disc
assembly. Install pinion gear and washer
onto hex shaft and slide shaft into right
bearing.
15. Install left bearing using hardware
removed in step 7.
16. Reinstall spring clip pin into hex shaft.
17. Connect adjustment pivot pin to speed
selector arm. See Speed Selector
Adjustment on page 28.
18. Install bottom cover.
19. Reinstall wheels.
20. Return unit to upright position.
21. Connect spark plug wire to spark plug.
22. Adjust traction drive clutch. See Traction
Drive Clutch Adjustment on page 31.
TRACK TENSION ADJUSTMENT
(Model 920022)
(Figures 40 and 41)
Check the track tension by applying pressure
on the track midway between the upper and
rear track rollers. Deflection should be
approximately 3/8" (9.5 mm) (Figure 40). If
deflection is excessive, tighten the track
tension.
If unit pulls to the left or right when a straight
path is desired, adjust the track tension. If the
unit is pulling to the left, tighten the left track
adjuster. If the unit is pulling to the right,
tighten the right track adjuster.
To adjust (Figure 41):
1. Tighten the adjuster nut to tighten the
track tension. Loosen the adjuster nut to
reduce track tension.
2. Check that unit tracks straight with no
pulling to either side.
Figure 39
1. Hex Shaft
2. Friction Disc Assembly
3. Left Bearing Flange
4. Speed Selector Arm
5. Friction Disc
6. Right Bearing Flange
7. Carrier Bearing
8. Spring Clip Pin
9. Pinion Gear
10. Drive Plate Assembly
1
Model 920022
6
2
3
5
10
4
9
7
8
Figure 40
3/8" (9.5 mm)
1. Drive Wheel
2. Wheel Clip
3. Flange Nut
4. Bogie Wheel
5. Drive Axle
1
5
2
3
4
Figure 41
Track
Adjusters
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Comments to this Manuals

No comments