Ariens 920013 Specifications download pdf (Page 23)

EN - 23

BOTTOM COVER REMOVAL

(Models 920013, 021)

1. Remove the six screws that attach the

bottom cover (4) to the frame and

remove the bottom cover.

2. Reinstall cover to the frame using six

screws.

(Model 920022)

(Figure 17)

1. Place the unit into the service position.

2. Remove the three top-lock flange nuts

(1) that hold the height adjuster plate (2)

to the height adjuster bracket.

3. Remove the height adjuster plate (2)

and the three spacers on the carriage

bolts. The height adjuster stop (3)

should now only be attached to the rear

axle.

4. Slide the height adjuster stop to the right

and rotate away from frame to make

room for the removal of the bottom

cover.

NOTICE: Track carriage can rotate freely

without the height adjuster stop attached to

the height adjuster bracket. BE CAREFUL to

keep fingers and hands out of pinch points.

5. Remove six screws that attach the

bottom cover (4) to the frame and

remove the bottom cover.

6. Rotate the track carriage as needed to

remove bottom cover.

7. Reverse steps 6 – 1 to install the bottom

cover.

GENERAL LUBRICATION

(Figures 18 and 19)

IMPORTANT: Wipe each fitting clean before

and after lubrication.

IMPORTANT: DO NOT allow grease or oil to

get on friction disc, friction plate or belts.

NOTICE: Apply Ariens Hi-Temp Grease or

equivalent to the lubrication fittings. See

SERVICE PARTS on page 37.

Sno-Thro should be lubricated at beginning of

season or every 25 operating hours.

Auger Shaft

NOTICE: To grease auger shaft, remove

shear bolt nuts and shear bolts. Apply grease

at the grease zerks and then turn the auger

assemblies on the auger shaft. Replace

shear bolts per instructions in Shear Bolts on

page 26.

Figure 17

1. Top-Lock Flange Nut

2. Height Adjuster Plate

3. Height Adjuster Stop

4. Bottom Cover

5. Rear Axle

2

1

3

4

5

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Comments to this Manuals

No comments