Ariens 920013 Specifications download pdf (Page 32)

EN - 32

Replace Attachment Drive Belt

1. Place new belt onto attachment pulley

(Figure 34).

NOTICE: Engage attachment clutch lever

while connecting housing to frame to hold

brake out of the way.

2. Tip housing and frame back together

and secure with hex bolts.

3. Place belt onto engine sheave.

4. Replace belt finger.

IMPORTANT: With the attachment clutch

lever engaged, the belt finger located

opposite the belt idler must be less than 1/8"

(3.2 mm) from the belt, but not touching the

belt, or belt grabbing may occur causing

impeller to rotate while the attachment clutch

is disengaged (Figure 35).

5. Adjust clutch per Attachment

Clutch/Brake Adjustment on page 28.

6. Replace chute crank and secure with

spring clip pin.

7. Models 920021, 022: Reconnect

remote deflector cable to control lever.

8. Replace gear cover on top of chute

pedestal.

9. Run in the attachment belt. See Run-in

Attachment Belt on page 11.

10. Replace belt cover and tighten

hardware.

WARNING: AVOID INJURY. Auger

must stop within 5 seconds when

attachment lever is released or

serious injury or unit damage may

result.

Figure 34

5

3

2

1

6

7

4

1. Traction Belt Idler

2. Traction Drive Belt

3. Engine Sheave

4. Belt Finger

5. Attachment Drive Belt

6. Attachment Pulley

7. Attachment Idler Nut

8. Attachment Belt Idler

8

Figure 35

1. Belt Finger

2. Attachment Drive Belt

3. Swing Gate Pivot Bushing

1

2

1/8" (3.2 mm)

(Maximum)

3

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments