Ariens 920013 Specifications download pdf (Page 36)

EN - 36

HEIGHT ADJUSTER CABLE

ADJUSTMENT

(Model 920022

(Figure 42)

1. Make sure that height adjustment lock

finger is fully engaged (Figure 42).

2. Loosen jam nuts on cable mount

bracket.

3. Adjust the jam nuts to remove all cable

slack and bring the overtravel arm into

slight contact with the right end of the

slot in the height adjuster lock finger.

4. Tighten the jam nuts.

SHORT TERM

IMPORTANT: NEVER spray unit with high

pressure water or store unit outdoors.

Run with attachment clutch engaged a few

minutes after each use to free unit of any

loose or melting snow.

Close fuel shut-off valve.

Inspect unit for visible signs of wear,

breakage or damage.

Keep all nuts, bolts and screws properly

tightened and know unit is in safe working

condition.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low

pressure water and lubricate (see

MAINTENANCE on page 21). Touch up all

scratched painted surfaces.

Remove weight from wheels by putting

blocks under frame or axle.

FUEL SYSTEM

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

IMPORTANT: NEVER store the engine with

fuel in the fuel tank inside of a building with

potential sources of ignition.

Add Fuel Stabilizer

1. Turn the fuel valve off while engine is

running and allow the engine to run until

it stops. Turn engine OFF when it begins

surging to avoid engine damage.

2. Add fuel stabilizer, following the

manufacturer’s instructions.

3. Turn fuel valve on after adding fuel

stabilizer.

4. Re-start engine.

5. Run the engine outdoors for 5 minutes to

be sure that treated gasoline has

replaced the untreated gasoline in the

carburetor.

6. Slow the engine to an idle speed.

7. Stop engine.

STORAGE

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Figure 42

1. Height Adjuster Lock Finger

2. Overtravel Arm

3. Height Adjuster Cable

4. Jam Nuts

3

2

1

Before adjusting ensure

that height adjuster lock

finger is fully engaged.

Pin on overtravel arm

makes slight contact

with end of slot.

4

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments