Ariens 932 Series Service Manual download pdf (Page 37)

12 - 37

SECTION 12 - TROUBLESHOOTING

Problem Probable Cause Correction

Engine will not crank/start.

1. Fuel tank is empty.

2. Fuel shut-off valve closed.

3. Build up of dirt and residue

around governor/carburetor.

4. Key switch not in run

position.

5. Ignition switch starter circuit

not functioning.

1. Fill fuel tank.

2. Open fuel shut-off valve.

3. Clean an area around governor/

carburetor.

4. Put key switch into run position.

5. Check for a bad starter or connections.

Engine stops.

1. Out of fuel.

2. Fuel shut-off valve closed.

3. Mechanical jam in blower

rake or impeller.

4. Polluted fuel supply.

5. Faulty spark plug.

1. Fill fuel tank.

2. Open fuel shut-off valve.

3. Turn off engine, remove key, and wait for

all moving parts to stop. Check for and

remove obstruction and repair before

restart.

4. Replace with clean fuel.

5. Replace or clean spark plug.

Engine Problems.

1. See Engine Manual.

Does not operate in Forward/

Reverse.

1. Friction disc not adjusted

properly.

2. Traction belt not functioning.

3. Speed selector not adjusted

properly.

1. Repair or replace fiction disc. See “Friction

Wheel Drive” on page 31.

2. Repair or replace traction drive belt. See

“Service and Adjustments” on page 21.

3. Adjust speed selector. See “Service and

Adjustments” on page 21.

Small rubber beads collect in

frame.

1. Friction disc wear. 1. Normal friction disc wear. Chunks or large

pieces of rubber mean friction disc should

be checked and replaced as necessary.

Unit throws snow poorly or

does not throw snow.

1. Shear bolts broken.

2. Attachment clutch/brake not

adjusted properly.

3. Attachment drive belt worn

or damaged.

1. Replace shear bolts (see “Shear Bolts” on

page 33).

2. Adjust attachment clutch/brake (see

“Attachment Clutch/Brake Adjustment” on

page 22).

3. Replace attachment drive belt (see

“Attachment Clutch/Brake Adjustment” on

page 22).

1 2 ... 32 33 34 35 36 37 38 39

Comments to this Manuals

No comments