Ariens 932 Series Service Manual download pdf (Page 32)

9 - 32

9.5 FRICTION PLATE

The friction plate can be removed and inspected when

the drive system, friction plate, and axle have been

removed. Refer to the appropriate sections of this

manual for more information.

1. Disconnect the friction plate return spring (Figure

24).

2. Slide friction plate off the hex shaft.

3. Inspect for wear.

4. When reassembling apply anti-seize to the shaft

before installing the friction plate.

9.6 FRICTION PLATE HEX SHAFT

To remove the shaft (Figure 24), place the unit in the

belt service position. Remove the front half of the frame

as shown in

Figure 9.

1. Remove the belt from the pulley.

2. Unscrew the bolt from the pulley and remove the

pulley.

3. Remove the hub key.

4. Tip the frame forward and remove the drive

system, friction wheel, and friction plate. Refer to

appropriate sections of this manual for more

information.

5. Pull the shaft out of the bearing assembly.

6. Reassemble in reverse order.

When installing the friction plate to the hex shaft,

use anti-seize on the shaft.

PS0342_1a

Figure 24

1. Friction Plate

2. Bearing Assembly

3. Retaining Ring

4. Shaft Spindle

5. Thrust Washer

6. Flange Bushing

7. Flange Bushing

8. Tension Spring

9. Clutch Fork

10.Traction Clutch

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39

No comments

Ariens 932 Series Service Manual Page 32