Ariens 932 Series Service Manual download pdf (Page 30)

8 - 30

8.1 WHEELS AND AXLE

The wheels are held onto the axle with locking pins

(

Figure 22). To remove a wheel pull the locking pin and

the wheel will slide off.

To remove the axle:

1. Place the unit in upright service position as shown

Figure 5.

2. Remove the lock pins from both ends of the wheel

axle and remove both wheels.

3. Remove two bolts from top of bottom cover.

4. Loosen two bottom screws and slide cover off.

5. Slide axle out either side. Be sure to catch larger

spur gear when removing axle.

NOTE: Make a record of the positions for the washers

and flanges for reassembly.

To install the axle:

1. Slide the axle into the main frame from either

direction.

2. Place flange bushing, washers, and spur gear on

the axle in the correct order.

NOTE: The flat side of the spur gear goes against the

frame. The flange bushings are installed from inside

the frame. The axle must enter into the bushings from

inside the frame toward the outside.

3. Insert the roll pin.

4. Install the bolt through the spur gear and install the

nut.

5. Slide washers on axle shaft outside of frame.

6. Slide wheels on axle shaft and install locking pins.

SECTION 8 - REDUCTION DRIVE

PS0333_1

1. Axle Lock Pin

2. Wheel

3. Steel Washer

4. Flanged Bushing

5. Steel Washer

6. Axle

7. Spur Gear

8. Bolt w/Nut

9. Roll Pin

Figure 22

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 30

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series