Ariens 932 Series Service Manual download pdf (Page 36)

11 - 36

11.1 ALUMINUM GEAR CASE

1. Remove auger/impeller and gearcase from

housing referring to Auger/Impeller Section.

2. Remove eight bolts that hold right and left gear

case halves together (

Figure 29).

3. If flange bushings need replacement, first remove

seals from outside of gearcase halves with a

screwdriver. Flange bushings can then be pressed

out from outside in with a bearing driver. Bushings

are very lightly pressed in.

4. When replacing bushings make sure the flat on the

flange of bushing fits in the inside notch of the

case.

5. There are two special thrust washers, one on

either side of worm gear. If burred or worn, they

should be replaced.

6. Holding the worm gear on rake shaft is a woodruff

key.

7. Remove bronze bushing from front of worm shaft

by sliding it off. Replace if necessary. Notice that a

flat on the bushing flange positions the bearing

inside the gearcase.

SECTION 11 - GEAR CASE

PS0381_1

202122

1. L2 Lube (16 oz)

2. Flat Washer (steel)

3. Oil Seal

4. Gearcase (right side)

5. Rake Shaft

6. Flange Bushing

7. Oil Seal

8. Worm Gear

9. Woodruff Key

10.Flange Bushing

11.Flange Bushing

12.Gearcase (left side)

13.Tapping Screw with Fiber

Washer

14.Steel Washer

15.Oil Seal

16.Steel Washer

17.Sleeve Bushing

18.Loctite Gasket 518

19.Worm Shaft

20.Thrust Collar

21.Flange Bushing

22.Sleeve Bushing

23.Groove Pin

24.Impeller

25.Flange Bearing

26.Tapping Head Washer

Hex Screw

Figure 29

1 2 ... 31 32 33 34 35 36 37 38 39

Comments to this Manuals

No comments

Ariens 932 Series Service Manual Page 36

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932 Series